DTX500 Module Setup Guide
1. Press the power switch while holding down the [SHIFT] button.
2. Check the number on the display that indicated in the picture below.
3. Set the trigger setup with the parameters listed below. The p arameters should be different
for each number which you’ve checked at procedure 2 above.
XP70
TRG2=Type
TRG3=Gain,MVl
TRG4=VelCurve
XP80
TRG2=Type
TRG4=VelCurve
PCY100
TGR2=Type
TRG4=VelCurve
Number = 1.00 Number = 1.10 Number = 1.20
For Snare : SN-1
For Tom : TM-1
*1
Gain*1 Gain*1
Gain
loud2 norm norm
Number = 1.00 Number = 1.10 Number = 1.20
For Snare : SN-1
For Tom : TM-1
loud1 norm norm
Number = 1.00 Number = 1.10 Number = 1.20
CY-1 / CY-2 / CY-3
norm norm norm
For Snare : SN-4
For Tom : TM-4
For Snare : SN-4
For Tom : TM-4
*
２
CY-1 / CY-2 / CY-3
For Snare : SN-7
For Tom : TM-7
For Snare : SN-6
For Tom : TM-6
*
２
CY-1 / CY-2 / CY-3
*
２
*1 In case if you feel the XP70 wouldn’t sound when you hit it softly, please increase the value of the parameter “Gain”
in TGR3 = Gain, MVl.
*2 “CY-1” is the setting that the sensitivities of the three sections(Bow / Edge / Cup) are the same.
“CY-2” is the setting that the sensitivity of the Edge section is set fairly lower than the other section.
“CY-3” is the setting that the sensitivity of the Cup section is set fairly lower than the other section.
APPENDIX : How to setup the trigger setup settings?
1. Press the [SHIFT] + [DRUM KIT] buttons to call up the Trigger Setup Select page (TRG1). The currently
selected Trigger Setup is indicated in the display.
* If you want to edit a different trigger setup, use the jog dial and select the setup here.
2. Press the [<]/[>] buttons to change pages(TRG2 through TRG8) and move the flashing cursor to the
parameter you want to set.
*To select the Trigger Input (input jack) you want to edit, simply hit the pad you want to edit or use the
[SHIFT] + [<]/[>] buttons.
3. Rotate the jog dial to change the setting as listed in the tables above.
4. Press the [SAVE/ENTER] button.
5. Rotate the jog dial to select the destination trigger setup number (8–11).
*If you want to change the Trigger Setup name, press the [<]/[>] buttons to move the flashing cursor to the
character you want to edit, then rotate the jog dial to select a character.
6. Press the [SAVE/ENTER] button again. A prompt appears asking you to confirm the Store operation.
7. Press the [SAVE/ENTER] button once more to actually execute the Store operation.
*For more information, please refer to the DTX500 Owner’s Manual.
Loading...