Yaesu FTDX3000 User Manual

05/12/20

FTDX3000 Firmware Update and Version

Identification

The latest versions are listed below with the release dates.

 MAIN Firmware Version 01-25 (05/12/20)
 DSP Firmware Version 05-55 (01/26/16)

 TFT Firmware Version 02-02 (09/28/17)

*If you already have the above listed firmware versions, it is not necessary to update the FT
again.

There are four different firmware installations. Each one must be followed carefully. Installing the
wrong type firmware may cause difficulties. Check your radio before installing firmware to be sure
which updates are needed.
If multiple firmware installations are required the MAIN firmware should be installed first, as it is the
only one that requires a press and hold in the [FAST] and [LOCK] keys while turning the radio back
on. This resets the radio and locks in the new firmware.

Before installing new firmware, please verify your current version firmware with the following
procedure:

DX3000

(This image & vers i on is fo r illu s tration only)

Download the FTDX3000 data and [FTDX3000_Firmware_update_202005.zip] from the following
website:

http://www.yaesu.com/indexVS.cfm?cmd=DisplayProducts&ProdCatID=102&encProdID=721B
3F7D596827E0B37BD528EE1A56F1&DivisionID=65&isArchived=0

The zip file contains all of the current firmware versions. Please verify which version firmware is
already on your radio before updating. If you have each of the listed versions, you do not need to
update the radio again.

Please read the FTDX3000 Firmware Upgrade Manual before proceeding!

Implements improvements
MAIN Firmware Version 01-25 (05/12/20)

The update content is the parameter setting menu of the microphone equalizer (MIC EQ) in AM/FM
mode. When the PROC is on, the microphone equalizer works properly.

NOTE:

*After updating the firmware; please reset the transceiver using the following procedure:

1. Press and hold the [POWER] key on the front panel to turn the transceiver ON.

2. While the transceiver is ON, disconnect the DC power cable from the DC-IN connector on the

rear panel and turn the transceiver OFF.

3. Press and hold the [FAST] and [LOCK] keys on the front panel, connect the power cable into the

DC-IN connector on the rear panel and turn the transceiver ON.