Whirlpool GSX 7984 INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

GSX 7984					Quick Reference Guide						GB

Options

On button

Time and failure display 3)

Indicates in hours the time remaining until the start of the wash cycle. Toward the end of the

Off button programme, during the drying cycle, the display will indicate the time remaining in minutes.

“F...” Information for the AfterSales Service

Programme selection button

Start button

Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

“Delayed start” button

The wash cycle can be programmed to start after 1 - 24 hours. Then press the Start button. The dishwasher will start at the set time.

	Programme chart			Detergent 2)		Consumption 3)
	Programmes		Loading instructions	A	B	Litres	kWh	Minutes
	Sensor Normal	40-55°C	Recommended programme for
			routine washes, for crockery with	X	X	13-16	0.8-1.05	50-120
			little dried-on food.
	Sensor Intensive 60-70°C		Recommended programme for
			heavily soiled crockery, especially	X	X	16-23	1.1-2.0	90-140
			suitable for pans and saucepans.
	Pre-Rinse	cold	Crockery to be washed later.	-	-	5.0	0.02	10
	Glass	40°C	Light soiling, for example glasses	X	-	13.0	0.90	55
			and cups.
	Rapid 30 min	40°C	Lightly soiled crockery with no	X	-	13.0	0.70	30
			dried-on food.
	Standard 1)	50°C	Normally or heavily soiled crockery.	X	X	16.0	1.05	120

1)Reference programme for energy label in compliance with EN 50242 regulations;

2)Refer to “User instructions“;

3)Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.

5019 496 90138

(We reserve the right to make technical modifications)

BK/I/FD/GB

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

	Open the door	Press the ON button.
	Switch on the appliance

		Large compartment A:
		With each wash cycle.	A B	C
How to fill the
detergent dispenser		Small compartment B:
		For programmes with pre-wash only.
		Mechanical indicator lamp C.
Check the
rinse aid level		Electric indicator on control panel (if provided).

Check the regeneration salt level

Load the racks

Select a programme

Select options

On models with water softener system only.

Mechanical indicator lamp D.

Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.

Press the button until the desired programme lights up.

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme

is then memorised (even

Press the START button in the event of power failure).

“Change programme”

PresstheSTARTbuttonfor2sec.until theStartindicatorlamp switchesoff; Select another programme and press the START button again.

Turn on the water tap close the dishwasher door

Wash cycle

Switch off the appliance

Shut off the water tap, unload the racks

-Only open the dishwasher if necessary (Warning: beware of hot steam).

-If the appliance is switched off during

a wash cycle, when switched on again it will resume the cycle from where it was interrupted.

At the end of the programme an acoustic signal will sound. Only after the START button has switched off: press the OFF button. All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

BK/II/FD/GB