Whirlpool GSX 5798 Quick start guide

GB GSX 5798

Quick Reference Guide

DYNAMIC SENSE: Energy savings and optimum wash results

The two sensor-controlled “DYNAMIC SENSE” wash options are recommended for routine washes. They use double-sensor

technology. Separate sensors gauge turbidity and particles in order

to determine the degree of soiling of the wash water. In accordance with values measured, a microprocessor establishes optimum water,

energy and time consumption. Optimum wash results are thus achieved using only those resources strictly required.

Further indications are given in the pages to follow and in the user instructions.

On button

Programme selection button

Delayed start buttons

Options

Off button

Start button

The wash cycle can be programmed to start after 1-24 hours. Then

press the Start button. The dishwasher will start at the set time.

Indicator lamp lit while the dishwasher is operating.

Time and failure display

Rinse aid level indicator

Flashes when a fault occurs.

Switches off at the end of the programme.

Indicates in hours the time remaining until the start of the wash

Add rinse aid.

Options

cycle. Switches off when the programme has started. Toward the

Salt level indicator

Half Load button

end of the programme, during the drying cycle, the display will

indicate the time remaining in minutes.

Add regeneration salt; only add

This function can be used with any programme.

“F1-F4”,“F7-F9” Identification of faults for service technician

regeneration salt immediately before

The indicator lamp switches on: the wash cycle is

“F6” Turn on the water supply tap.

starting a wash programme.

activated for the upper or lower rack only.

Place the detergent in the:

Consumption 1)

small

large

Programme Symbol

Programme selection and

Normal load / (Half load)

compartment

and Temperature

recommended load type

Water

Energy

Time

(Litres)

(kWh)

(Min.)

Eco Normal 40 - 55° C

Recommended programme for routine washes, for crockery

(13.5)

(1.3)

(80)

with little or no dried-on food.

(11.5)

(0.9)

(60)

Intensive 60 - 70° C

Recommended programme for heavily soiled crockery, with

(19.5)

(1.7)

(98)

dried-on food. Especially suitable for pans and saucepans.

(11.5)

(1.3)

(90)

Pre-wash

Crockery to be washed later.

5.0

(4.2)

0.02

(0.02)

(9)

Rapid 40° C

Lightly soiled crockery with no dried-on food.

13.0

(13.0)

0.85

(0.75)

(30)

Glasses 40° C

Light soiling, especially glasses and cups.

12.0

(10.5)

0.82

(0.78)

(59)

Bio-Normal 50° C 2)

Normally or heavily soiled crockery with dried-on food.

16.0

(14.5)

1.03

(0.90)

120

(117)

Values may vary in relation to usage, e.g.: different loads, water

5019 100 90308

temperatures - above or below 15° C - as well as water hardness and power supply voltage etc.

Reference programme for Test Institute and energy-label.

(We reserve the right to make technical modifications)

How to use the dishwasher

Upper and lower rack

1.After loading the dishwasher, turn on the water supply tap and open the dishwasher door.

2.Press the On button to switch the dishwasher on. One of the programme indicator lamps will light up.

3.Press the programme selector button until the corresponding indicator lamp switches on. If required, select options (if supplied).

4.Press the Start button to start the selected wash programme. The Start indicator lamp will light up. Once set, the programmed data cannot be altered by pressing the programme selector buttons.

Note: once the Start button has been pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply.

To change the selected

programme, open the door

(caution: danger of scalding from steam!) and press the Start button for about 5 seconds, until the Start indicator lamp switches off.

Select a new programme and press the Start button again.

Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.

Only open the dishwasher door if strictly necessary during a wash

cycle and exercise maximum caution. Danger of scalding from steam.

5To indicate the end of a programme, an acoustic signal is activated 4 times, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for about 30 min.).

6.Only open the door once the wash cycle has terminated (caution: danger of scalding from steam) and press the OFF button to switch the dishwasher off. All the indicator lamps switch off.

7.Unload the lower rack before the upper one. Close the water tap.

Upper rack

Half Load:

If the upper rack only is to be loaded, place the cutlery basket “B” on the upper rack.

Rack height adjustment:

(The dishwasher is delivered with the upper rack in the top position).

The rack height can also be changed when loaded.

•To lower: pull out the two side handles and gently lower the rack.

•	To raise: pull up the two side handles
	until the rack clicks into place.
•	The rack must be level on both sides.
Crockery holders:
•	Down: cups and long-stemmed glasses.	A
•	Up: plates.	A

Lower rack

“Vario Organizer” multi-purpose support:

•To be used, for example, for longhandled utensils (arrange knives with the blade facing downwards), cups and glasses.

•May be used in three different positions (see also “Dishwasher loading instructions” on Page 4).

1.Upon the left-hand side of the rack.

2.Upside-down, towards the centre of the rack.

3.Upside-down, towards the left side.

Glass holder:

Half Load:

Loading the lower rack only gives greater washing power, especially for plates and saucepans.

Plate holders:

•May be lowered to increase available space (A).

Cutlery basket:

•The cutlery basket can be removed to increase (B + C) available space.

•Some models are provided with a grid (D) that can be fitted onto the cutlery basket.

B	D
	D
	C

Please read the user instructions carefully.

+ 2 hidden pages