DIGIPHONEKIT DK918 1 DK918 1S
SMART 1
IMPORTANTE!
ESEGUIRE I COLLEGAMENTI COME DA SCHEMA.
IMPORTANT!
SYSTEM MUST BE WIRED AS PER INSTRUCTION.
IMPORTANT!
REALISER LES CABLAGES COMME INDIQUÉ SUR LE SCHEMA.
WICHTIG!
VERKABELUNG GEMMASS DES SCHEMAS DURCHFUHREN.
IMPORTANTE!
EFECTUAR LAS CONEXIONES SEGUN EL ESQUEMA.
-Citofono
-Intercom
-innenstelle
-Poste d’appartement
-Telèfono
Art. 522
-Alimentatore
-Power supply
-Netzeil
-Alimentation
-Alimentador
Art. 836-1
-Modulo portiere elettrico
-Speaker unit module
-Aussenstelle mit Sprecheinheit
-Groupe phonie
-Unidad de habla/Botonera con parlante
Art. VX800-2L
-Tastiera digitale apriporta
-Codelock
-Codeschloß Modul
-Clavier de codage
-Modulo botonera digitale abrepuerta
SE
-Serratura elettrica (non inclusa)
-Electric lock (not included)
-Elektrisches Turschloß (nicht imbegriffen)
-Serrure èlectrique (non includ)
-Cerradura elèctrica (no incluida)
Lock release back EMF protection: A capacitor must be fitted across the terminals on an AC lock release and diode must be fitted across the terminals on a DC lock release to suppress back EMF voltages. The diagrams below show how to connect these components to the lock releases.
Buzzer back EMF protection: On each telephone add one 0,1 uF capacitor between terminals 6 - 7 (3).
Cable size and type: When running cables for any intercom system, these cables must be installed separately. from the mains cables. All multipair cables should be to CW1308 specification. (0.5mm twisted pair telephone cable).
Max resistance = 10 Ohm.
Lock release wires should be doubled up. Maw resistance = 3 Ohm.
The cables sizes above can be used for distances up to 50m. On distances above 50m the cable sizes should be increased to keep the overall resistance of the cable below the RESISTANCES indicated above.
Loading...