Unimac UTEE5ASP Installation Manual

4.5 (2)

Installation Instructions

for Stacked Washer/Dryers

Original Instructions

Keep These Instructions for Future Reference.

(If this machine changes ownership, this manual must accompany machine.)

www.alliancelaundry.com

Part No. 805501EN

 

October 2014

Front Matter

Front Matter

WARNING

WARNING

Risk of fire. Highly flammable material.

W881

Read all instructions before using unit.

WARNING

FOR YOUR SAFETY, the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death.

W033

WARNING

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Clear the room, building or area of all occupants.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

W052

IMPORTANT: Purchaser must consult the local gas supplier for suggested instructions to be followed if the dryer user smells gas. The gas utility instructions plus the SAFETY and WARNING note directly above must be posted in a prominent location near the dryer for customer use.

Part No. 805501EN

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT

3

Front Matter

WARNING

Installation of unit must be performed by a qualified installer.

Install clothes dryer according to manufacturer’s instructions and local codes.

DO NOT install a clothes dryer with flexible plastic venting materials. If flexible metal (foil type) duct is installed, it must be of a specific type identified by the appliance manufacturer as suitable for use with clothes dryers. Refer to section on connecting exhaust system. Flexible venting materials are known to collapse, be easily crushed, and trap lint. These conditions will obstruct clothes dryer airflow and increase the risk of fire.

W729R1

WARNING

To reduce the risk of severe injury or death, follow all installation instructions. Save these instructions.

W894

WARNING

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

W053

This product uses FreeRTOS V7.2.0 (www.freertos.org).

Electric models are approved by CSA-International.

4

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT

Part No. 805501EN

Table of Contents

 

Front Matter..........................................................................................

3

Dimensions.............................................................................................

6

Installation.............................................................................................

9

Before You Start.............................................................................................

9

Tools..........................................................................................................

9

Order of Installation Steps............................................................................

9

Position Unit Near Installation Area.................................................................

9

Remove Shipping Materials.............................................................................

9

Connect Fill Hoses........................................................................................

10

Water Supply Requirements.......................................................................

11

Connecting Hoses......................................................................................

11

Risers.......................................................................................................

11

Connect Drain Hose to Drain Receptacle.........................................................

12

Standpipe Installation................................................................................

12

Wall Installation........................................................................................

12

Laundry Tub Installation............................................................................

13

Gas Dryers - Connect Gas Supply Pipe...........................................................

14

Connect Dryer Exhaust System......................................................................

15

Exhaust Direction......................................................................................

16

Exhaust System.........................................................................................

16

Position and Level the Unit............................................................................

17

Wipe Out Inside of Washer and Dryer Drums..................................................

18

Connect Unit to Electrical Power....................................................................

18

Stacked Washers and Electric Dryers Equipped with Lead-In Cord................

18

Stacked Washers and Electric Dryers Not Equipped with Lead-In Cord..........

19

Earth/Ground and Wiring Instructions.........................................................

19

Stacked Washers and Gas Dryers................................................................

19

Earth/Ground Information..........................................................................

20

Check Installation.........................................................................................

21

Check Heat Source........................................................................................

21

Electric Dryers..........................................................................................

21

Gas Dryers................................................................................................

21

Installer Checklist.................................................................................

22

© Copyright 2014, Alliance Laundry Systems LLC

All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher.

Part No. 805501EN

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT

5

Unimac UTEE5ASP Installation Manual

 

 

 

Dimensions

 

 

Dimensions

 

Electric Models

C

 

 

 

 

 

 

 

G

 

 

 

F

 

 

D

 

 

A

E

 

 

B

 

L

 

 

 

 

H

 

 

M

 

 

 

J

 

 

Q

 

 

 

O

K

I

 

P

N

SWD1003N_SVG

A

* 1678 mm [66.06 in.]

 

 

B

* 1447 mm [56.97 in.]

 

 

C

597 mm [23.5 in.]

 

 

D

213 mm [8.375 in.]

 

 

E

610 mm [24 in.]

 

 

F

203 mm [8 in.]

 

 

G

391 mm [15.4 in.]

 

 

H

* 938 mm [36.9 in.]

 

 

I

* 368 mm [14.5 in.]

 

 

J

* 813 mm [32 in.]

 

 

K

683 mm [26.875 in.]

 

 

L

* 1184 mm [46.62 in.]

 

 

M

* 1986 mm [78.17 in.]

 

 

N

52 mm [2.04 in.]

 

 

O

704 mm [27.73 in.]

 

 

P

38 mm [1.5 in.]

 

 

Q

* 333 mm [13.1 in.]

 

 

Part No. 805501EN

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT

6

Dimensions

* With leveling legs turned into base.

NOTE: Exhaust openings are 102 mm [4 inch] metal ducting.

Gas Models

 

 

 

C

 

 

 

 

F

 

G

 

 

1

D

 

 

 

 

 

E

O

 

H

A

 

 

 

B

 

N

I

 

 

 

 

L K

 

 

 

S

 

 

 

 

Q

M

J

R

P

 

SWD1004N_SVG

1. 3/8 in. NPT Gas Connection

 

 

 

A

*1678 mm [66.06 in.]

 

 

B

*1447 mm [56.97 in.]

 

 

C

597 mm [23.5 in.]

 

 

D

213 mm [8.375 in.]

 

 

E

610 mm [24 in.]

 

 

F

203 mm [8 in.]

 

 

G

391 mm [15.4 in.]

 

 

H

59 mm [2.3 in.]

 

 

I

*938 mm [36.9 in.]

 

 

J

*368 mm [14.5 in.]

 

 

K

*1140 mm [44.87 in.]

 

 

L

*813 mm [32 in.]

 

 

M

683 mm [26.875 in.]

 

 

N

*1184 mm [46.62 in.]

 

 

O

*1986 mm [78.17 in.]

 

 

P

52 mm [2.04 in.]

 

 

Q

704 mm [27.73 in.]

 

 

R

38 mm [1.5 in.]

 

 

Part No. 805501EN

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT

7

Dimensions

S

*333 mm [13.1 in.]

* With leveling legs turned into base.

NOTE: Exhaust openings are 102 mm [4 inch] metal ducting.

8

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT

Part No. 805501EN

Loading...
+ 16 hidden pages