Installation Guide
CO29A and CO29FF
Ice Maker/Refrigerators
www.U-LineService.com
Phone (414) 354-0300 • FAX (414) 354-7905
Service & Parts Tech Lines Phone (800) 779-2547 • FAX (414) 354-5696
OnlineService@U-Line.com
©2005 U-Line Corporation
02/2005
CO29A and CO29FF Ice Maker/Refrigerators
Contents
Exterior Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Cut-Out Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Product Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Door Swing/Clearances Information . . . . . . . . . . . . . . 4
Reversing the Door. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Other Site Requirements . . . . . . . . . . . . . . . . . . . . . . . . 6
Custom 1/4" Thick Door Panel Insert . . . . . . . . . . . . . . 7
Checking Door Alignment . . . . . . . . . . . . . . . . . . . . . . 8
Adjusting Door Alignment . . . . . . . . . . . . . . . . . . . . . . 8
Water Supply Connection . . . . . . . . . . . . . . . . . . . . . . . 8
Electrical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . 9
Leveling Information . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Installation of the CO29A/CO29FF . . . . . . . . . . . . . . . . 10
Grille Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Glass Shelf Installation . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Installation Troubleshooting . . . . . . . . . . . . . . . . . . . . . 11
Initial Start-Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Start-Up Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . 12
Service Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
1 Follow Safety Precautions
IMPORTANT
PLEASE READ all instructions completely before attempting to install or operate the unit.
•This unit requires connection to the water supply. Improper hook-up can result in substantial property damage! If you are unsure of your ability to safely connect the water supply to the unit, consult a licensed plumber for assistance.
•This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician in accordance with applicable electrical codes.
Safety Alert Definitions
Safety items throughout this guide are labeled with a Danger, Warning or Caution based on the risk type:
DANGER
Danger means that failure to follow this safety statement will result in severe personal injury or death.
WARNING
Warning means that failure to follow this safety statement could result in serious personal injury, or death.
CAUTION
Caution means that failure to follow this safety statement may result in minor or moderate personal injury, property or equipment damage.
www.U-LineService.com |
2 |
02/2005 |
CO29A and CO29FF Ice Maker/Refrigerators
General Precautions
Use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide:
WARNING
SHOCK HAZARD — Electrical Grounding Required.
•Keep the unit unplugged throughout installation except during testing.
•Never remove the round grounding prong from the plug and never use a two-prong grounding adapter.
•Never use an extension cord to connect power to the unit.
•Always keep your working area dry.
CAUTION
•Use care when moving and handling the unit. Use gloves to prevent personal injury from sharp edges.
•Do not lift the unit by the door or door handle.
•Do not install the unit behind closed doors or in any way that would obstruct airflow to the front grille, which may cause the unit to malfunction.
2 Inspect and Plan
You have received a carton containing your CO29A or CO29FF Ice Maker/Refrigerator with a package inside containing a User Manual, a Product Registration Card and water connection parts. Complete and mail the Product Registration Card or register online at www.U-LineService.com. Once your unit is installed, keep the User Manual and this Installation Guide in a safe place for future reference.
CO29A/CO29FF units are available in vinyl clad cabinets with matching doors which have a slightly contoured handle across the top and are reversible. The doors have recessed front panels that will accept a custom 1/4 inch thick door panel. Units have two tempered glass shelves.
Please carefully follow the directions that apply to your unit and your intended design.
Tools/Materials Required
•Screwdrivers — slotted and Phillips head
•1/4-inch OD copper tubing and shut-off valve for water supply line
•1/4-inch thick door panel material and cutting tools
Inspection
Unwrap and inspect the unit on a flat, level surface capable of supporting its entire weight.
Exterior Cleaning
(As Required)
Black and White Models:
Black and white surfaces may be cleaned with a mild detergent and warm water solution. Do not use solventbased or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft, clean towel to prevent water spotting.
02/2005 |
3 |
www.U-LineService.com |
CO29A and CO29FF Ice Maker/Refrigerators
3 Prepare Site
Your U-Line product has been designed for either freestanding or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must NOT be obstructed and clearance is required for water and electrical connections in the rear.
Note: Unit can NOT be installed behind a closed cabinet door.
Cut-Out Dimensions
|
Filler Panel (Not Provided by U-Line) – |
|
|
May Be Added Above or Below Unit |
|
|
to Enclose for a Built-In Look |
|
Typical |
See Electrical |
|
Counter |
||
Specifications |
||
Height |
||
for Power Supply |
||
34-1/4" |
||
|
||
to |
24" |
|
35-1/8" |
Minimum |
|
Cut-Out |
|
|
Height |
|
|
28-5/8" |
|
|
to |
|
|
28-7/8" |
8" |
|
|
||
|
21-1/16" |
|
Figure 1 |
|
Product Dimensions
24" Including Handle
28-1/2"
20-13/16"
Figure 2
Door Swing/Clearances Information
Units have a zero clearance for the door to open
90° (see Figure 3). U-Line recommends a minimum door clearance of 1/4" to accommodate the handle if the unit is right-hand hinged and installed next to a wall or similar type of structure.
Units require a minimum of 1" door clearance if installed flush with cabinet or wall and 9" clearance if installed adjacent to cabinet or wall if the unit is left-hand hinged for easy removal of ice bin. See Figure 3.
Follow the cut-out drawing in Figure 1. The 21-1/16" width allows 1/4" for ease in installation and removal of the unit. 24" is the counter depth in most installations. The unit is 24" deep including the door and handle (see
Figure 2).
IMPORTANT
It is extremely important that the unit sits on a level surface, as it does not have feet levelers. If it is not level, the ice mold will not fill evenly.
www.U-LineService.com |
4 |
02/2005 |
Loading...