LTU-Pro Quick Start Guide
LTU-Pro Quick Start Guide
Click for
Table of Contents
Package Contents
LTU-Pro Mount Bracket Bracket Clamp
×
Bracket Clamp Carriage Bolts (Qty. 2) Flange Nuts (Qty. 2)
Gigabit PoE (24V, 0.5A) with
Mounting Bracket
Installation Requirements
LTU PtMP AP, such as model LTU-Rocket
13 mm wrench
Power Cord
Surge protection should be used for all outdoor installations. We recommend that you use
two Ethernet Surge Protectors, model ETH-SP-G2, one near the device and the other at the
entry point to the building. The ETH-SP-G2 will absorb power surges and safely discharge
them into the ground.
Note: For guidelines about grounding and lightning protection, follow your local
http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]
LTU-Pro Quick Start Guide
electrical regulatory codes.
Outdoor, shielded Category 6 (or above) cabling and shielded RJ45 connectors are
required for all wired Ethernet connections.
Hardware Overview
http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]
LTU-Pro Quick Start Guide
5 GHz LED
Reset Button
To reset to factory defaults, press and hold the Reset button for more than 10 seconds
while the device is powered on.
USB-C Port
Reserved for future use.
http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]
LTU-Pro Quick Start Guide
Blue The LED will light blue when the link is active.
GPS LED
Blue
UNMS LED
Flashing White Bootup in progress.
White
The LED will light blue when the GPS signal strength is
sufficient. This requires a minimum of three satellite
connections.
Ready for use, not connected to Ubiquiti® Network
Management System (UNMS™). See
“UNMS
Management”.
Blue Ready for use, connected to UNMS.
Steady Blue with Occasional
Flashing
Ready for use, unable to connect to UNMS, check
connection to UNMS server.
Quickly Flashing Blue Used to locate a device in UNMS.
Alternating
Blue/White
Firmware upgrade in progress.
LAN LED
The LED will light steady blue when an active Ethernet
Blue
connection is made to the Ethernet port and flash when
there is activity.
Power LED
Blue
The LED will light blue when the device is connected to a
power source.
PoE In [24V] Port
This 10/100/1000 Ethernet port is used to connect the power and should be connected to
the LAN and DHCP server. Default IP address: 192.168.1.20
Pole Mounting
1.
http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]
LTU-Pro Quick Start Guide
2.
3.
http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]
LTU-Pro Quick Start Guide
4.
5.
http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]
Loading...