Sony XR-C2604J Users guide
Connection diagram
Equipment used in illustrations (not supplied)
3-044-706-11 (1)
#######
#######
Front speaker
#######
Rear speaker
#######
For connecting two or more changers, the source selector XA-C30 (optional) is necessary.
Power amplifier
#######
CD/MD changer
#######
A
BUS AUDIO IN
FM/MW/SW
Cassette
Car Stereo
#######
Installation/Connections
#######
B
BUS CONTROL IN
BUS AUDIO IN
BUS CONTROL IN
AUDIO OUT
(LINE OUT)
XR-C2604J
Sony Corporation © 2000 Printed in Japan
Parts list
The numbers in the list are keyed to those in the instructions.
1 2
#####
#######
34
Notes
• Be sure to connect the earth cord before connecting the amplifier.
• If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will
be deactivated.
#####
####### •
####### •
C
BUS AUDIO IN
Source selector
#######
BUS CONTROL IN
× 4
##
5
The release key 6 is used for dismounting the unit. See the Operating Instructions manual for details.
Cautions
•Cautionary notice for handling the bracket 1.
Handle the bracket carefully to avoid injuring your fingers.
• Remove the protection collar 5 before installing.
67
#####
#######•
#######•
1
#######
5
Release the catch lock as illustrated.
#######
Installation
#######
Precautions
•Choose the installation location carefully so that the unit will not interfere with normal driving.
•Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as
in direct sunlight or near heater ducts.
•Use only the supplied mounting hardware for a safe and secure installation.
Mounting angle adjustment
Adjust the mounting angle to less than 20°.
How to detach and attach the front panel
Before installing the unit, detach the front panel.
A To detach
Before detaching the front panel, be sure to press (OFF). Press (RELEASE), then slide the front panel a
little to the left, and pull it off towards you.
B To attach
Attach part A of the front panel to part B of the unit as illustrated and push the left side into position
until it clicks.
(OFF)
A
#######
####### •
####### •
####### •
#######
#######
########
#######
##### A
#######
#######
##### B
#######
#######
B
A
B
(RELEASE)
Mounting example
Installation in the dashboard
1 2
182 mm
53 mm
1
Bend these claws outward for a
tight fit, if necessary.
#######
#######
3
Dashboard
5
With the UP marking up
#######
#######
Fire wall
#######
2
1
First attach 5 to the unit, then insert the unit into 1.
3
#######
#######
#####
#####
Mounting the unit in a Japanese car
You may not be able to install this unit in some makes of Japanese cars. In such a case, consult your Sony
dealer.
TOYOTA NISSAN
4
max. size
5 × 8 mm
#####
#####
Bracket
#######
Existing parts supplied with your car
to dashboard/center console
######
4
max. size
5 × 8 mm
#####
#####
Bracket
#######
#######
4
max. size
5 × 8 mm
#####
#####
to dashboard/center console
Bracket
#####
Bracket
#####
Existing parts supplied with your car
#######
#######
#######
#######
4
max. size
5 × 8 mm
#####
#####
Note
To prevent malfunction, install only with the supplied screws 4.
#####
########
Loading...