Sony BDV-L800 Users guide

Quick Setup Guide

8097

5 64

2 31

HDMI

HDMI

BDV-L800

©2011 Sony Corporation Printed in Malaysia

(1)

4-279-074-11(1)

English

Setting up the speakers

1

1. Connect the speaker cords to the subwoofer.

Rear of the front speaker

2. Remove the panel cover from the main unit.

Press the panel cover at () gently, then slide it out to the side.

Rear panel of the subwoofer Rear of the front speaker

Red (Front right
speaker (R))

White
(Front left speaker (L))

Connect your TV and other components

2

1. Connect a High Speed HDMI cable to your TV.

Depending on the jacks on your TV, select the video and audio
connection method.

High Speed HDMI cable*

* Not supplied

2. Connect a High Speed HDMI cable to your set-top box, game

console or digital satellite receiver.

4. Bring together the cables (except the FM wire antenna (aerial)),

guide them through the slot at the right of the main unit,
behind the clamp (), and through the slot at the bottom of
the main unit.
Thread the FM wire antenna (aerial) through the small
indentation at the rear of the main unit.

FM wire antenna (aerial)

Perform “Easy Setup”

3

Do not insert a disc before performing the “Easy Setup”.

1. Insert batteries into the remote.

2. Connect the AC power cords (mains leads) of the main unit and

subwoofer.

3. Insert the wireless transceivers into the main unit and

subwoofer.

Wireless transceiver

High Speed HDMI cable*

* Not supplied

3. Plug the connector of the AC adapter into the DC IN 14V

connector on the rear of the main unit.
Thread the AC power cord (mains lead) through the gap on the
main unit by securing it behind the tabs, guide it through the
slot at the left of the main unit, behind the clamp (), and
through the slot at the bottom of the main unit.

5. Attach the panel cover to the rear of the main unit.

Put the left edge of the lower part of the panel cover on (), align the
bottom projection of the panel cover with (), and then slide it inward
until it clicks into place.

FM wire antenna (aerial)

6. Attach the stand cover to the rear of the main unit.

Align both edges of lower part of the stand cover with the guides on the
stand (), and then slide the stand cover down gently.

3. Press

After the subwoofer turns on, the LINK/STANDBY indicator () turns
green and the wireless transmission is activated.

on the main unit to turn the system on.



4. Turn on the TV, and switch the input selector on your TV so

that system screens like the ones below appear on the TV
screen.

Starting up “Easy Setup” screen

4. Position the speakers.

Wireless transceiver

5. Perform basic settings by following the on-screen instructions

in “Easy Setup” using /// and .

Tabs

///,

[Easy Setup is now complete.] appears when “Easy Setup” is complete.