SGS Thomson Microelectronics ST72T91L, ST7291L6, ST7291L5A, ST7291L5, ST7291L4 Datasheet

...
December 1997 1/5
Thisispreliminaryinformation ona newproductin development orundergoingevaluation. Detailsaresubject to change without notice.
R
ST7291L
8-BIT MCU WITH 8/12/16/24/32K ROM, TIMER, SUPPLY
SUPERVISOR AND CARRIER FREQUENCY GENERATOR
BRIEF DATA
8MHz Maximum Clock Frequency
Fully Static Operation
0to+70°C Operating Temperature Range
Run, Wait, Stop and RAM Retention modes
User ROM: 12/16/24/32 Kbytes
Data RAM: 256/384 bytes
28 pin SO Plastic Packages
21 Bidirectional I/O lines
8 standard Push-pull I/Os with wake-up feature
13 standard Push-pull I/Os
16-bit Timer with Output Compare (no output
pin)
Low Voltage Detector (LVD)
Interrupt Wake-up function
IR Carrier Frequency Generator
8-bit Data Manipulation
63 Basic Instructions
17 main Addressing Modes
8x8 Unsigned Multiply instruction
True Bit Manipulation
Complete Development Support on PC/DOS/ Windows 3.1x/95/NT with Real-Time Emulator
Full Software Package (Cross-Assembler,
Debugger)
Full Hardware Emulator
EPROM and OTP support
DEVICE SUMMARY
Note 1. This device is in development, consult your
SGS-THOMSON representative for the current status.
Figure 1. Pin Description
Notes:
1. PC1 on ST7291L2/L3/L4; software selectable as OP on ST7291L6/L5/L5A
DEVICE
ROM
(Bytes)
RAM
(Bytes)
CARRIER
GENERATOR
ST7291L6
(1)
32K 384 Yes ST7291L5 24K 384 Yes ST7291L5A 16K 384 Yes ST7291L4 16K 256 No ST7291L3 12K 256 No ST7291L2 8K 256 No
PSO28
(See end of Datasheet for Ordering Information)
1 2 3 4 5 6 7 8 9 10 11 12 13
14
15
16
17
18
19
20
V
DD
RESET
WKP
PA7 PA6
PA1
PC0
PA5 PA4 PA3
OSCin OSCout
PC1/OP
(1)
PC6 PC7
PB6 PB5 PB4 PB3
PB2
28 27 26 25 24 23 22 21
PA2
PA0 PB0
PB1
V
SS
TEST PC5 PB7
1
2/5
ST7291L
1 GENERAL DESCRIPTION
1.1 INTRODUCTION
The ST7291L CMOS Microcontroller Unit is a member of the ST7 family of microcontrollers. The device is based on an industry-standard 8-bit core and features an enhanced instruction set. Oscilla­tor frequency may be as high as 8MHz, however, thanks to the fully static design, operation is possi­ble down to DC. Under software control, the ST7291L may be placed in either WAIT or HALT modes, thus reducing power consumption.
The enhanced instruction set and addressing modes afford real programming potential. In addi­tion to standard 8-bit data management, the ST7291L features bit manipulation, 8x8 unsigned multiplication and indirect addressing modes.
The device includes a CPU, ROM, RAM, I/O, an on-chip oscillator, a timer with output compare system and, depending on theversion, aLow Volt­age Detection (LVD) and Carrier Frequency gen­eration for remote control applications.
Figure 2. ST7291L Block Diagram
OSCILLATOR
ADDRESS BUS
PORT A
PORT B
CARRIER FREQ.
8 BIT CORE
PA0..PA7 (8-bit)
PB0..PB7 (8-bit)
PC0, PC1, PC6, PC7
PORT C
V
DD
LOW VOLTAGE
DETECTOR
TIMER
SYSTEM
V
PP
PC5
PCL
PCH
SP
XYA
CC
CONTROL
Internal CLOCK
ROM
8K/12K/16K/24K/32K
RAM
256/384
GENERATOR
OSCout
OSCin
WKP
RESET
DATA BUS
Loading...
+ 3 hidden pages