QUARTZ METRONOME
SQ50V
NAMES AND FUNCTIONS OF PARTS
Power switch
•Slide the switch to turn ON/OFF power.
•Changes over tempo sound between "S1" and "S2" in metronome mode.
•Changes over reference note between "A4" and "B 4"
in reference note generation mode.
Setting dial
Turn dial to set indicator to desired tempo speed or reference note.
Reference note mark (A4/B 4)
Set setting dial 
to this mark to generate reference note.
LED tempo display
The red LED flashes to the tempo you have set.
Speaker
It gives out tempo sound and the reference note.
Volume dial
It adjusts volume of tempo sound and reference note.
Earphone jack
Insert earphone plug into it to use with earphone.
Prop-up stand
HOW TO USE
●Metronome Mode
•Set indicator of setting dial to desired tempo speed.
•Slide power switch 
to S1 or S2 to select desired tempo sound.
●Reference Note Generation Mode
•Set indicator of setting dial 
to reference note mark 
.
•Slide power switch 
to A4 or B 4 to select desired reference note.
*The reference note generation mode is useful for tuning musical instruments.
HOW TO INSTALL THE BATTERY
Slide battery hatch in direction of arrow in the illustration, and remove it.
Connect dry battery with battery plug, checking that (+) and (-) terminals are correctly connected.
*Be sure to use a specified 9V dry battery (6F22) only.
*Before changing battery, check that metronome is turned off.
*When battery nears its end, the metronome may not work properly. Replace the battery with a new one immediately.
*The battery included with your metronome when it was purchased is a monitor battery, and may not last as long as specified.
*When disposing of old battery, observe the regulations of authorities concerned.
Loading...