Schneider Electric VTR8300 Series Installation Manual

VTR8300 Series Installation Guide

Room Controller with Optional PIR sensor

Commercial and Hotel/Lodging HVAC Fan Coil Applications

CONTENTS

Installation 2

Location 2
Installation 2

Terminal, Identification and Function 3
Communication wiring to VC3xxxE Relay Pack 3

BACnet® Communication Wiring (if applicable) 3

Network wiring topology 3

How to Enter Setup Screen 4
Setup Screen Display 4
Specifications 5
Drawing and Dimensions 6

2

Installation Guide

VTR8300 Series

DISCLAIMERS

• The VTR8300 series Room Controller is only to be used in conjunction with the VC3000 line voltage switching relay pack. Together
they are used as operating controls for high voltage fan coil units.

• If replacing an existing Line Voltage FCU Controller, label the wires before removal of the Room Controller.

• Electronic controls are static sensitive devices. Discharge yourself correctly before manipulating and installing the Room Controller. A

short circuit or wrong wiring may permanently damage the Room Controller or equipment.

• All VTR8300 series Room Controllers are designed for use as operating controls only and are not safety devices. These instruments
have undergone rigorous tests and verification prior to shipping to ensure proper and reliable operation in the field. Whenever a control
failure could lead to personal injury and/or loss of property, it becomes the responsibility of the user/installer/electrical system designer
to incorporate safety devices such as relays, flow switches, thermal protections, and/or an alarm system to protect the entire system
against any catastrophic failures. Tampering with the devices or unintended application of the devices results in a void of warranty.

• If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired.

• These devices are not serviceable and must be returned to the supplier for any repair.

• A switch or circuit breaker must be installed. It must be suitably located, easily reached, and marked as the disconnecting device

• Never apply more than 9VDC to Room Controller.

• This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.

IMPORTANT SYMBOLS

Products marked with this symbol state that the manuals must be consulted in all cases to any hazards.

This product has been tested to the requirements of CAN/CAS-C22.2 No. 61010-1, second edition, including Amendment 1,
or a later version of the same standard incorporating the same level of testing requirements.

Alternating Current

Direct Current

Equipment protected throughout by DOUBLE INSULATION or REINFORCED INSULATION

VTR8300 Room Controller VC300 0 Relay Pack

Viconics Technologies Inc.

02 8- 0414- 02 Ap ri l 2 015

© 2015 Viconics Technologies Inc. All rights reserved.