07 Bulb exchange
08 Door removal
08 Door glass removal
09 Auto energy saving function
09 Correct disposal of this product
(Waste electrical & Electronic equipment)
09 Installation
11 Oven controls
11 Accessories
12 Setting the clock
13 Initial cleaning
14 Setting the cooking function mode
15 Setting the oven temperature
15 Switching the oven o
16 End time
16 Cook time
17 Delayed start
18 Kitchen timer
19 Auto cook
20 Oven lamp on / o
20 Child safety function
21 Switching the beeper o
22 Oven functions
31 Test dishes
32 Catalytic enamel surface (optional)
32 Hand cleaning
32 Water collector cleaning
33 Detaching the side runners (optional)
33 Cleaning the ceiling (optional)
34 Troubleshooting
34 Information codes
Thank you for choosing SAMSUNG Built - In Oven.
This user Manual contains important information on safety and instructions
intended to assist you in the operation and maintenance of your appliance.
Please take the time to read this Owner’s Manual before using your oven
and keep this book for future reference.
The following symbols are used in the text of this Owner’s Manual:
WARNING or CAUTIONImportantNote
safety instructions
Installation of this oven must be performed only by a licensed electrician.
The installer is responsible for connecting the appliance to the mains power
supply in observance of the relevant safety recommendations.
WARNING
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
If the supply cord is defective, it must be replaced by a
special cord or assembly available from the manufacturer or
an authorised service agent. (Fixed wiring type model only)
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard. (Power cord type
model only)
Appliance should allow to disconnection of the appliance
from the supply after installation. The disconnection
may be achieved by having the plug accessible or by
incorporating a switch in the fixed wiring in accordance
with the wiring rules.
During use the appliance becomes hot. Care should be
taken to avoid touching heating elements inside the oven.
WARNING: Accessible parts may become hot during
use. Young children should be kept away.
If this appliance has steam or self cleaning function,
excess spillage must be removed before cleaning and
all utensils should not be left in the oven during steam
cleaning or self cleaning. (cleaning function model only)
If this appliance has self cleaning function, during self
cleaning the surfaces may get hotter than usual and
children should be kept away. (Cleaning function model
only)
Only use the temperature probe recommended for this
oven. (Temperature sensing probe model only)
A steam cleaner is not to be used.
WARNING: Ensure that the appliance is switched o
before replacing the lamp to avoid the possibility of
electric shock.
Do not use harsh abrasive cleaners or sharp metal scrapers
to clean the oven door glass since they can scratch the
surface, which may result in shattering of the glass.
WARNING: The appliance and its accessible parts
become hot during use. Care should be taken to
avoid touching heating elements. Children less than 8
years of age shall be kept away unless continuously
supervised.
8years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
The temperature of accessible surfaces may be high
when the appliance is operating.
The door or the outer surface may get hot when the
appliance is operating.
Keep the appliance and its cord out of reach of children
less than 8 years.
Appliances are not intended to be operated by means of
an external timer or separate remote-control system.
Please put the bent up frame side to the
back, in order to support the restposition
when cooking big loads. (Depending on
model)
CAUTION
If the oven has been damaged in transport, do not connect it.
This appliance must be connected to the mains power supply only by a specially
licensed electrician.
In the event of a fault or damage to the appliance, do not attempt to operate it.
Repairs should be performed by a licensed technician only. Improper repair may
result in considerable danger to you and others. If your oven needs repair, contact a
SAMSUNG Service Centre or your dealer.
Electrical leads and cables should not be allowed to touch the oven.
The oven should be connected to the mains power supply by means of an approved
circuit breaker or fuse. Never use multiple plug adapters or extension leads.
The power supply of the appliance should be turned o when it is being repaired or
cleaned.
Take care when connecting electrical appliances to sockets near the oven.
If this appliance has steam cooking function, do not operate this appliance when the
water supply cartridge is damaged. (Steam function model only)
When the cartridge is cracked or broken, do not use it and contact your nearest
service center. (Steam function model only)
This oven has been designed only for the cooking of household foods.
During use, the oven interior surfaces become hot enough to cause burns. Do not
touch heating elements or interior surfaces of the oven until they have had time to
cool.
Never store flammable materials in the oven.
The oven surfaces become hot when the appliance is operated at a high temperature
for an extended period of time.
When cooking, take care when opening the oven door as hot air and steam can
escape rapidly.
When cooking dishes that contain alcohol, the alcohol may evaporate due to the high
temperatures and the vapour can catch fire if it comes into contact with a hot part of
the oven.
For your safety, do not use high-pressure water cleaners or steam jet cleaners.
Children should be kept at a safe distance when the oven is in use.
Frozen foods such as pizzas should be cooked on the big grid. If the baking tray is
used, it may become deformed due to the great variation in temperatures.
Do not pour water into the bottom of the oven when it is hot.
This could cause damage to the enamel surface.
The oven door must be closed during cooking.
Do not line the oven bottom with aluminium foil and do not place any baking trays or
tins on it. The aluminium foil blocks the heat, which may result in damage to the enamel
surfaces and cause poor cooking results.
Fruit juices will leave stains, which can become permanent on the enamel surfaces of
the oven. When cooking very moist cakes, use the deep pan.
Do not rest bakeware on the open oven door.
Keep children away from the door when opening or closing it as they may bump
themselves on the door or catch their fingers in the door.
Do not step, lean, sit or place heavy items on the door.
Do not open the door with unnecessarily strong force.
WARNING: Do not disconnect the appliance from the main power supply even
after the cooking process is completed.
WARNING: Do not leave the door open while oven is cooking.
Danger of electric shock! Before replacing any of
the oven bulbs, take the following steps:
• Switch oven O.
• Disconnect the oven from the mains.
• Protect the oven light bulb and the glass cap by laying a
cloth on the bottom of the oven compartment.
• Bulbs can be purchased from the SAMSUNG Service
Centre.
Rear oven light
1. Remove cap by turning anti-clockwise
and remove the metal ring, the sheet ring
and clean the glass cap. If necessary,
replace the bulb with a 25 watt, 300 °C
heat-resistant oven light bulb.
2. Clean the glass cap, the metal ring and the sheet ring if
necessary.
3. Fit the metal and the sheet ring to the glass cap.
4. Replace glass cap where you have removed it in step 1
For normal use, the oven door must not be removed but if removal is necessary, for
example, for cleaning purposes, follow these instructions.
CAUTION: The oven door is heavy.
2
70
1
1. Open the door and flip
open the clips at both
hinges completely.
2. Close the door by
approximately 70 °.
With both hands, grasp
the sides of the oven
door at its middle and
lift and pull upwards
until the hinges can be
3. After cleaning, for
attaching the door
repeat the 1 sides 2
steps in revers order.
The clip on the hinge
should be closed on
both sides.
taken out.
DOOR GLASS REMOVAL
The oven door is equipped with three sheets of glass placed against each other. These
sheets can be removed for cleaning.
1. Press both buttons on
the left and right sides
of the door.
The Door-Glass is dierent from 2 EA to 4 EA model by model.
But, the method of the disassembly and assembly is same.
2. Detach the covering
and remove glass 1
from the door.
3. Lift glass 2 and clean
the sheets with warm
water or washing-up
liquid and polish dry
with a soft clean cloth.
When assembling the glass 1, the screen printed surface of the glass 1 should be
on the inside, between the glass sheets.
• If you do not select any function when appliance is in the middle of setting or
operating with temporary stop condition, function is canceled and clock will be
displayed after 10 minutes.
CORRECT DISPOSAL OF THIS PRODUCT
(WASTE ELECTRICAL & ELECTRONIC EQUIPMENT)
(Applicable in countries with separate collection systems)
This marking on the product, accessories or literature indicates that the product and its
electronic accessories (e.g. charger, headset, USB cable) should not be disposed of with
other household waste at the end of their working life. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, please separate these
items from other types of waste and recycle them responsibly to promote the sustainable
reuse of material resources.
Household users should contact either the retailer where they purchased this product, or
their local government oce, for details of where and how they can take these items for
environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the
purchase contract. This product and its electronic accessories should not be mixed with
other commercial wastes for disposal.
installation
Safety instructions for the installation
This oven may be installed only by an approved electrician. The installer is responsible for
connecting the appliance to the main supply, while observing the relevant safety regulations.
• Ensure protection from live parts when installing the oven.
Power connection
If the appliance is not connected to the mains with a
plug, a multi-pole isolator switch (with at least 3 mm
contact spacing) must be provided in order to satisfy
safety regulations. The power cable (H05 RR-F or H05
VV-F, min., 2.5 mm²) must be of sucient length to
be connected to the oven, even if the oven stands on
the floor in front of its built-in cabinet. Open the rear
connection cover of the oven with a screwdriver and loosen the screws of the cable
clamp before you connect the power lines to the relevant connection terminals. The oven
is earthed via the ( )-terminal. The yellow and green cable(earth connection) must be
connected first and be longer than the others. If the oven is connected to the mains with
a plug, this plug must remain accessible after the oven is installed. Samsung will take no
responsibility for accidents that originate from a missing or faulty earth connection.
WARNING: Do not allow the connecting cable to become trapped during
installation, and prevent it coming into contact with hot parts of the oven.
With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of
the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic
surfaces or adhesive from the heat.
1
545
595
595
560
572
21
Lower
2
element
Airflow through the ventilation gap
Top element
There should be a ventilation gap
in the base of the kitchen cabinet
where the oven is to be placed. For
ventilation, a gap of about 50 mm
should be left between the lower shelf
and the supporting wall. If the oven is
to be installed below a hob, the hob’s
installation instructions should be
followed.
3
min.
550
Lower element
min. 560
min. 50
min. 600
4
min. 590 -
max. 600
min. 560
Top element
5
min. 550
50
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make
sure that a gap of at least 5 mm should be left between the appliance and the adjacent cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside
of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and
release the 2 screws on the both sides of the oven.
WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow
as shown on picture. Do not cover this hole with strips of wood, for this is used to
provide ventilation.
The front exterior of the oven such as handle is dierent model by model. But the
size of the oven in the picture is same.
The Cooking Function Select Dial and the Time / Temp Control Dial are pop -
up dial. Simply push to turn.
13
2
8
accessories
CAUTION: Be sure to attach the accessory correctly to the racks. Trays need to
have at least 2 cm space towards the bottom of the oven, otherwise the enamel
surface could be damaged.
WARNING: Be very carefull removing meals and/or accessories out of the oven.
Hot meals, accessories and surfaces can burn you!
Baking tray
The baking tray could be used for the preparation of cakes, cookies
and other pastries.
Deep pan (Optional)
The deep pan is good for roasting. It can be used in combination with
the small grid to prevent liquids from dropping onto the bottom of the
oven.
Small grid (Optional)
The small grid should be used for grilling and roasting meals. It can
be used in combination with the
dropping onto the bottom of the oven.
Wire grill (Optional)
The wire grill should be used for grilling and roasting meals. You
could use it with casseroles and other baking pots.
Telescopic slide guide (Optional)
• To insert the grid, baking or roasting pan, first slide out the
telescopic guides for one particular level.
• Place the tray or pan on the guides and push them back
completely into the oven. Close the oven door only after you
have pushed the telescopic guides into the oven