Salter Brecknell HS-200M User Manual

Page 1
HS-200M HEALTH SCALE
The Health Scale HS-200M can both weigh the body and measure the height. The designation of the product meets the OIML international Recommendation R76. The scale has the advantages of large weighing range, accuracy and high sensitivity. It is ideal for school nurse’s offices or for doctor’s screening rooms where height and patient weight is necessary. It is also can be used for weighing other things.
Specification:
1. Maximum capacity 160kg/350lb,180kg/400lb,200kg/450lb;
Graduation 100g/0.25lb Height rod range 60-210cm Min.value of height per division 5mm
2. Platform size 375x275cm
3. Overall dimension (LxWxH) 530x275x1485mm
Installation Instruction:
1
Page 2
I. Pillar Installation (Fig.2):
1. Upright insert the pillar to the bracket on frame
2. Use the screws and washer to fix the pillar in a vertical position
II. Connect the steelyard rod to long lever (Fig.3):
2
Page 3
1. Lay the pillar on a table (Fig.3)
2. Disassemble the wires on the levers.
3. Insert the wrench to the small hole in front of the steelyard rod, and pull the
hook of steelyard rod with the hook of wrench (Fig. 3-1)
4. Push the long lever frontward, then hook the bearing of the steelyard rod on the
pivot of the long lever (Fig. 3-2)
5. Take away the wrench form the draft rod (Fig.3-3)
6. Put the scale on ground gently
III. Height rod Installation (Fig.4):
3
Page 4
1. Insert the back side holes of the height rod into the two bolts on the front side of
pillar, loose the height rod downwards on right position. (Fig.4-1)
2. Use the wrench to tighten the two hex-head screws. Do not overtighten the
screws.
3. Take away the wrench from the two hex head screws. (Fig.4-3)
IV. Moving Wheel Installation (Fig.5):
1. Turn the angle iron of wheel and make one side upwards, the other side with
two holes opposite to the backside of frame (Fig.5-1)
2. Use the screws and washers to fix the wheel to the pl atform, adjust the angle
iron at a level position, then tighten the screws.
3. When moving the scale, hold the two side faces of the pillar to keep the front
side of the platform away from ground.
USA
Brecknell
1000 Armstrong Drive
Fairmont MN 56031
Toll Free: 800-637-0529
Tel: 507-238-8702
Fax: 507-238-8271
Email:sales@brecknellscales.com
www. brecknellscales.com
4
Wed site: www. brecknellscales.co.uk
Tel: +44 (0) 845 246 6717
Email: sales@brecknellscales.co.uk
UK and Europe
Brecknell
Foundry Lane
Smethwick,
West Midlands, B66 2LP.
Fax: +44 (0) 845 246 6718
Loading...