Rockwell Automation 1753-OPC User Manual

Installation Instructions

GuardPLC OPC Server

(Catalog Numbers 1753-OPC)

System Requirements

Before you install the GuardPLC OPC software, make sure your personal computer meets the following system requirements:

Category Requirement

Personal Computer

Operating System

RAM 128 MB

Free Hard Disk Space at least 150 MB plus space for user programs

Ethernet Card(s) up to 4, configured for TCP/IP

Pentium

Windows

II, 350 MHz

2000/ Windows NT®/ Windows XP

Publication 1753-IN007B-EN-P - July 2005

Installing GuardPLC OPC Software

You must have administrator access to the computer on which you are installing the OPC server.

1. Insert the GuardPLC OPC Server CD-ROM into the CD drive.

If Autoplay is enabled, the software installation starts automatically. If this is not the case, you can start the installation by clicking on d:\RSLogix_Guard_PLUS_OPCServer\setup.exe (where “d” is your CD drive).

2. On the setup screen, click on Install GuardPLC OPC Server and follow the installation prompts. You will be prompted to enter your serial number, which is found on your license agreement.

TIP

To uninstall the GuardPLC OPC server, use the

Add/Remove Programs tool in your Windows® Control Panel.

GuardPLC is a trademark of Rockwell Automation, Inc. Pentium is a registered trademark of Intel. Windows and Windows NT are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.

Publication 1753-IN007B-EN-P - July 2005 PN 40071-168-01(2)