PURE ChargePAK User & Fitting Manual

Portal > FAQs > All Other Radios > Fitting a Pure ChargePAK

Fitting a Pure ChargePAK

Pure Support - UK - 2015-05-27 - in All Other Radios

Add a ChargePAK rechargeable battery pack and listen to your Pure radio wherever you go.

ChargePAKs are much more economical than regular batteries and significantly kinder to

the environment, reducing the quantity of batteries that end up in landfill sites

Easy to install – can be fitted in seconds

Easy to use – just fit and forget

Charges inside the radio, no separate charging unit required

Increased battery life per charge over standard rechargeable batteries

Replaces the need for throwaway alkaline batteries

Provides many hours of wireless listening

This guide will show you how to fit your Pure ChargePAK to your Pure radio. Before you

start ensure the following is in place:

Ensure your ChargePAK is unpacked and ready to install.

Ensure you have your Pure radio with you and disconnected from the mains power supply.

Installing your ChargePAK – C6L, E1, B1

The ChargePAK plugs in to a socket in the battery compartment of the PURE radio. The

battery plug is made up of a number of pins that will correspond to the socket in the radio.

The pin numbers vary depending on the type of ChargePAK you are using. The example

pictures below show the 4pin C6L ChargePAK connectors.

You'll also notice the battery plug and socket are 'keyed' meaning that the plug can only be

plugged in to the socket one way round. In the example picture above, the key appears on

the bottom of the socket as two gaps. Likewise the plug will have two protrusions that fit

these gaps.

To fit your ChargePAK simply line up the plug with the socket pins, ensure the key side is

correct, and push the plug in until it clicks and locks in to place.

Now push the battery in to the battery compartment and close the compartment door.

Fitting ChargePAK A1, D1

The ChargePAK plugs in to the green tab in the battery compartment of the Pure radio.