InstructionSheet
InstructionSheet
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .06251800
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
INSTALLATION INSTRUCTIONS
CFT926/32/42 EB/EBDM
1.
Bend brackets as shown. Install the fixture
in the ceiling using mounting channel or
bar (by others) placed in the adjustable
mounting brackets. Mount the fixture in
the ceiling so that the weight of the fixture
is supported by the mounting channel or
bar and/or hanger wires secured to the
building structure.
2. Adjust the fixture so the bottom of the
plaster flange is flush with the finished
ceiling line and in alignment with adjacent
fixtures. Secure mounting brackets by
tightening wing nuts on either side of
the fixture.
3. Determine where the supply wiring
conduit will enter the J-Box and attach
it in conformance with the National
Electric Code.
Reflector
Holding
Clips (4)
lign Brackets with
A
arks on Flange
M
J-Box Cover
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
Low voltage dimming wires
(Dimming units only)
Use this Position for 42
Watt Lamp.
Use this Position for 32
Watt Lamp.
Use this Position for 26
att Lamp.
W
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND PROPER
TION OF THE FIXTURE DEPEND ON THE INTEGRITY
OPERA
Socket
Mounting
Bracket
Reflector
OF THE WIRING.
4. Remove J-Box cover plate. Remove
appropriate knockout and assemble
appropriate connector for the supply wire
used. Connect ground wires to green
ground leads. Connect white (common) to
white (leads). Connect power supply (line)
to black lead(s). Reinstall J-Box cover.
WARNING: DO NOT pinch wires
between J-Box/ballast cover and J-Box.
Consult a Qualified Electrician for all
other options that require other wiring
configurations.
Install reflector
5.
and finishing work is complete. Insert
socket mounting bracket into correct position depending on lamp wattage.
6. Push reflector into the plaster flange until
the reflector is flush against the ceiling.
7. Install the proper lamps (by others).
after all ceiling installation
701 Millennium Boulevard • Greenville, SC 29607
With representatives of
Copyright 2007, 02/07 revision, All Rights Reserved - Printed in U.S.A.
fices in principal cities throughout North
America.
Loading...