InstructionSheet
InstructionSheet
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
INSTALLATION INSTRUCTIONS
Part No. ................................06268700
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
CFSCB 813/18/26
Outlet Box
(By Others)
1. Remove cover plate by loosening the (2) cover
plate screws and sliding the cover plate until screw
heads clear the keyholes.
2. Thread supply wire (line, common and ground)
from outlet box installed in ceiling through center hole of drum housing. Place drum housing
over outlet box. Twist drum housing clockwise
to engage outlet box screw heads. Secure drum
housing to ceiling.
3. Make wire connections in top of drum housing
between supply wires and ballast/socket tray
assembly. (green to green, white to white and
black to black).
4. Install (2) compact fluorescent lamps per relamp
label (order separately).
5. Install trim (order separately).
Outlet Box
Screw Head
Cover Plate
Screw Head
Drum Housing
Cover Plate
(2) Compact
Fluorescent Lamp
(order separately)
701 Millennium Boulevard • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2012, 02/20/12 revision, All Rights Reserved - Printed in U.S.A.
CB8CL Trim
(order separately)
Loading...