Prescolite CFR6EB User Manual

InstructionSheet
InstructionSheet
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other poten­tial hazard. Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in compliance with the National Electrical Code and local codes. The use of accessory
equipment not recommended by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
INSTALLATION INSTRUCTIONS
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 05935800
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
CAT. NO. CFR6EB
IMPORTANT: FOR WALL WASH UNITS ONLY-FIXTURE MUST BE INSTALLED WITH J-BOX CLOSEST TO THE WALL TO BE
1. Bend brackets as shown in Detail “A”. Install
the fixture in the ceiling using mounting chan­nel or bar (by others) placed in the adjustable mounting brackets. Mount the fixture in the ceiling so that the weight of the fixture is supported by the mounting channel or bar and/or hanger wires secured to the building structure.
2. Adjust the fixture so the bottom of the plaster
flange is flush with the finished ceiling line and in alignment with adjacent fixtures. Secure mounting brackets by tightening wing nuts on either side of the fixture.
3. Remove J-Box cover plate. Remove appropriate
knockout and assemble appropriate connec­tor for the supply wire used. Connect ground wires to green ground leads. Connect white (common) to white (leads). Connect power sup­ply (line) to black lead(s). Reinstall J-Box cover.
WARNING: DO NOT pinch wires
between J-Box/ballast cover and J-Box. Consult a Qualified Electrician for all other options that require other wiring configurations.
4. Connect the Mate-N-Lock Connectors from the ballast to the connectors from the fixture. Push all connectors and
splices into the J-Box.
5. Install the ballast assembly by positioning the tab on the ballast mounting plate in the slot on the J-Box bottom plate. Secure bal­last assembly by snapping plate under J-Box Spring and bending spring down (See Detail “B”). WARNING: Do Not pinch Wires
between Ballast and J-Box or between J-Box and covers!
6. After all ceiling installation and finishing work
is complete. Install the reflector.
7. Install the proper lamps (by others).
ILLUMINATED.
Press Spring Down on Both Sides
of the
J-Box
DETAIL B
Wing Nut
Bend Brackets in Line with Marks on Flange
DETAIL “A”
Dimming Control Leads where applicable
For Wall Wash Units: This Side Closest to Wall to be illumi­nated
Ballast
Assembly
Adjustable
Mounting
Bracket
NOTE: Brackets are supplied flat. To insure proper align­ment, bend brackets in line with marks on flange as shown in detail “A”.
Mate-N-Lock
Connectors
where appli-
J-Box
When Wall
Wash Trim is
used, This End
of fixture must
be positioned
towards the
Tab
cable
wall.
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND PROPER
WARNING- This product contains chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
701 Millennium Blvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America. Copyright 2009, 10/29 revision, All Rights Reserved - Printed in U.S.A.
Loading...