InstructionSheet
BEND BRACKETS IN
LINE WITH MARKS
ON FLANGE
WINGNUT
J-BOX
DETAIL "A"
FOR WALL WASH UNITS:
THIS SIDE CLOSEST TO
WALL TO BE ILLUMINATED
ADJUSTABLE
MOUNTING
BRACKET
NOTE: BRACKETS ARE
SUPPLIED FLAT. TO INSURE
PROPER ALIGNMENT, BEND
BRACKETS IN LINE WITH
MARKS ON FLANGE AS
SHOWN IN DETAIL "A".
REFLECTOR
InstructionSheet
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and
instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and
proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during
servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard. Product must be mounted in locations and at heights and in a manner consistent with its
intended use, and in compliance with the National Electrical Code and local codes. The use of accessory
equipment not recommended by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do
not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items such
as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as this may
cause an unsafe condition.
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
INSTALLATION INSTRUCTIONS
IMPORTANT: FOR WALL WASH UNITS ONLY-FIXTURE MUST BE INSTALLED WITH J-BOX CLOSEST TO THE
WALL TO BE ILLUNINATED.
1. Bend brackets as shown in Detail “A”.
Install the fixture in the ceiling using
mounting channel or bar (by others)
placed in the adjustable mounting
brackets. Mount the fixture in the ceiling so that the weight of the fixture is
supported by the mounting channel or
bar and/or hanger wires secured to the
building structure.
2. Adjust the fixture so the bottom of the
plaster flange is flush with the finished
ceiling line and in alignment with adjacent fixtures. Secure mounting brackets
by tightening wing nuts on either side of
the fixture.
3. Determine where the supply wiring
conduit will enter the J-Box and attach
the conduit in conformance with the
National Electric Code.
4. Connect power supply leads to black
(line) and white (common) ballast leads.
Connect ground wires.
5. After all ceiling installation and finishing
work is complete. Install the reflector.
6. Install the proper lamps (by others).
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . 158630100
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
CAT. NO. CFR6126EB
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND
PROPER OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
701 Millennium Boulevard • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2009, 12/07/09 revision, All Rights Reserved - Printed in U.S.A.
Loading...