English - 3 -
Connecting power
Power Adapter connection
The TV set is designed to operate on 12 V DC. For
this, an adaptor is used which gives 12 V voltage.
Connect this adaptor to a system that supplies 110240V AC,50/60Hz.
Cigarette lighter plug connection
Connect the cigarette lighter plug cable to the cigarette
lighter socket of your car or a cable with clips to the
battery of car, making sure to observe the correct
polarity.
Plug the other side of 12 volt cable to DC 12 socket at
the back of the TV. Then the standby LED lights up.
ATTENTION: 12 V Input :
V+
V+
V-
V-
Switching on/off
To switch the TV on
To switch on the TV from standby mode either:
• Press the “
” button, CH- or CH+ or a numeric
button on the remote control.
• Press the side function switch until the TV comes
on from standby.
Note: If the TV has been left on and not been operated for a
while, the TV will go into standby. When you next switch-on,
the following message will be displayed. “Standby Cause
No Operation” Press OK to continue.
To switch the TV off
• Press the “ ” button on the remote control or
press the side function switch until the TV switches
into standby mode.
Note: To power down the TV completely, unplug the power
cord from the mains socket.
First time installation
You will see the language selection screen when you
rst turn on your TV. Select your preferred language
and press OK followed by the selection Home Mode/
Shop Mode.
You can set up your TV by following the First Time
Installation (FTI) screen with the following selections.
Aerial installation
Select the AERIAL option from the Search Type
screen to search for terrestrial digital TV broadcasts.
Optional a channel list, which is generated by LCN (*),
will be displayed on screen when the search is over.
Select “Yes” and press OK to store this list.
Press “
” button to quit channel list and watch TV.
(*) LCN is the Logical Channel Number system that
organizes available broadcasts in accordance with a
recognizable channel sequence (if available).
Notications, features and accessories
Energy efciency
This TV is designed with energy efcieny features:
• Power save mode (ECO or On/Off(*)): You can
apply a combination of energy saving picture
settings. While you watch TV, press the Menu button
and, the Power Save Mode settings can be found in
the ‘Picture’ section of the Main Menu.
• Picture off mode(**): If you only want to listen to
audio from the TV, you can switch off the display.
Other functions continue to operate normally. While
you watch TV, press Menu and select Picture, and
from there select ‘Picture off’ under the Power Save
Mode option.
Note: Disconnect your TV from the mains plug in
case your TV is going to be inactive for a long time.
(*) for 22PFL2978H/12 only
(**) for 22PFL2978K/12 only
TV scroll button
The TV Scroll button on the side of the TV allows you
to control the volume, change channels and put the
TV into standby.
To change volume: Increase the volume by scrolling
up. Decrease the volume by scrolling down.
To change channel:
1. Press the middle of the scroll button, the channel
information banner will appear on screen.
2. Scroll through the stored channels by pushing the
button up or down.
To change source:
1. Press the middle of the button twice, the source list
will appear on screen.
2. Scroll through the available sources by pushing the
button up or down.
To switch the TV to standby: Press the middle of
the button down and hold it down for a few seconds,
the TV will turn into standby mode.