Peerless-AV LCH-100 Installation
Installation and Assembly - Monitor Desktop Stand
A
Models: LCH-100
IMPORTANT! Read entire instruction sheet before you start installation and assembly.
IMPORTANT! The product is made to support screens with a Vesa compliant hole pattern.
For safe mounting, mounting screws must turn at least three times in the screen inserts.
Parts List
Description Qty. Part #
telescopic pedestal 1 091-1088
B pivot head 1 091-1090
C mounting base 1 091-1089
D adapter plate 1 095-1100
M4 x 8mm countersink screw
E
M4 x 10mm phillips screw
F
wood screw #14 x 1
G
H hex bolt 1 -
I hex nut 1 -
J M4 x 0.7mm nut 4 530-1082
K pressure plate 1 -
L nylon washer 1 540-1636
M 4mm allen wrench 2 560-0072
N 3mm allen wrench 1 560-0073
NOTE: You may not use all hardware provided.
NOTE: Some parts may not appear exactly as illustrated.
LCH-100
520-1795
4
520-1796
4
510-9159
4
MAX Load Capacity:
25 lb (11.4KG)
WARNING
SPRING LOADED PRODUCT
• Only release lock ball when screen is
installed. Do not place chin or object
above pole when releasing lock ball.
LCH-100
LOCK BALL
C
A
B
D
E
M
K
F
G
H
I
J
L
N
2300 White Oak Circle • Aurora, Il 60502 • (800) 865-2112 • Fax: (800) 359-6500 • www.peerless-av.com
ISSUED: 09-30-02 SHEET #: 090-9085-6 07-23-13
CAUTION
• Mount must be installed on wood and/or wood composition surfaces of at least 3/4" thick. However, the installer
must ensure that the mounting surface will safely hold the combined weight of the mount and the screen. See other
mounting requirements below.
There are two methods of installation. Follow step 1 for installation using hex bolt and pressure plate or
step 2 using four wood screws.
Mark hole on desktop for positioning mount.
Drill one 1/2" dia. hole through desktop. Attach
mounting base (C) to desktop using hex bolt (H),
pressure plate (K), and hex nut (I). Tighten nut
using proper sized wrench.
Important! Mount is to be installed onto desktops
3/4" to 1-5/8" thick only! For thicker mounting
surfaces, you may have to provide your own
hardware.
H
C
Use four holes on mounting base (C) to mark holes
on desktop for positioning mount. Drill four 3/16"
dia. holes through desktop. Attach mounting base
(C) to desktop using four wood screws (G).
G
C
DESKTOP
K
I
Insert telescopic pedestal (A) into mounting base (C).
Tighten set screws where shown with 3 mm allen wrench (N).
SET SCREWS
DESKTOP
A
C
2 of 5
ISSUED: 09-30-02 SHEET #: 090-9085-6 07-23-13
Loading...