Panasonic AW-CB400N Menu Information

Panasonic Broadcast

AW-CB400N

Menu Information

16

$ Operation method

The GAIN information appears first when the OPERATE
switch is set to ON.

When the MENU button is pressed, the display changes in
the sequence shown below, after which the display returns
to the gain setting screen.

Z Gain setting

;

Z Pedestal setting

;

Z

DTL setting (when SCENE FILE is set to the USER mode)

Z DTL setting (when 1, 2 or 3 is set for SCENE FILE)

;

Z Camera settings

;

Z Remote operation panel settings

;

Z LCD off

(LCD off)

(ROP settings)

(Camera setting items)

DETAIL

HIGH

DETAIL H DETAIL

15

PEDESTAL T: 0

R: 0 B: 0

GAIN 0dB

R: 0 B: 0

1 Gain setting

The gain of the camera selected by the CAM CONTROL
button is set on this display.
The analog gain-up value appears on the right of the top
line, and the gain information for the lighted GAIN button
is displayed.
The R gain and B gain settings are shown on the bottom
line.
When the R or B GAIN dial is turned, the R or B gain is
incremented or decremented. The value which can be set
differs depending on the camera concerned.
The values corresponding to white balance A and B can
be stored in the memory. When the automatic adjustment
mode (ATW among the ATW, A and B buttons) has been
selected for the white balance, “– – –” appears on the
display, and the gain cannot be set.

2 Pedestal setting

The pedestal of the camera selected by the CAM
CONTROL button is set on this display.
The total pedestal setting is shown on the top line, and
the R pedestal and B pedestal settings on the bottom
line.
When the R or B PED dial is turned, the R or B pedestal
is incremented or decremented. The value which can be
set differs depending on the camera concerned.

3 DTL setting

The horizontal detail and vertical detail of the camera
selected by the CAM CONTROL button is set on these
displays.
When USER is selected for SCENE FILE, any value from
0 to 63 can be set as the H DETAIL and V DETAIL level.
Press the CONT switch to switch between H and V.
When 1, 2 or 3 is set for SCENE FILE, use the CONT dial
to switch between HIGH and LOW.

4 Camera settings

The detailed settings of the camera selected by the CAM
CONTROL button are set on these displays.
Turn the CONT dial to select the setting item, and press it
to display the settings on the bottom line. If the CONT
dial is turned while the setting is displayed, the setting
can be changed. Upon completion of the setting, press
the CONT dial to clear the bottom line display, and
another setting item can now be selected.

5 Remote operation panel settings

The controller settings are set on these displays.
Operation is the same as that for “4 Camera settings”.

6 Exiting the setting menu

Press the MENU button to exit the setting menu.

Menu settings