Page 1
C-760 Ultra Zoom
E. NOTICE OF MODIFICATION
1. Version-up of firmware 1 ......................................................................................E-2
2. Version-up of firmware 2 .....................................................................................E-3
Rev.3
E-1 Ver.1
Page 2
E. NOTICE OF MODIFICATION
C-760Ultra Zoom
Subject
Version-up of firmware 1
2005.Jan.28
DESCRIPTION : Change of firmware for C-760 Ultra Zoom
OLD NEW
Ver.771-77 Ver.771-78
REASON : Countermeasure of following items for C-760 Ultra Zoom
1) High-speed sequential shooting may cause noisy picture when the resolution is setup to SHQ.
REMARKS : Update procedure
>Please refer to D-3 of Service Manual
Change classification
>Running change
Rev.3
E-2 Ver.1
Page 3
C-760 Ultra Zoom
E. NOTICE OF MODIFICATION
Subject
Version-up of firmware 2
2005.Jan.28
DESCRIPTION : Change of firmware for C-760 Ultra Zoom
OLD NEW
For all distination: Ver.771-78 Ver.771-79
REASON :Countermeasure of following items for C-760 Ultra Zoom
1) Zooming available while setting the date and time at Full-auto shooting mode.
2) Part of information fails on LCD monitor.
>>The failure could be reproduced by the following procedure.
1. Turn Mode Dial to Full-Auto shooting mode and press OK button to display top menu.
2. Display menu by pressing Self/Remote button or popping the flash up. If left key is pressed
before menu automatically disappears and top menu appears, part of menu is not displayed.
3) Camera hangs up by disconnecting the USB cable while downloading the firmware.
4) Self-timer LED remains blinking until the camera turned off even if updating of the firmware is
complete.
5) Flash stand-by mark on LCD monitor doesn’t appear.
>>The failure could be reproduced by the following procedure.
1. Set the flash to UP-position.
2. Change shooting mode to Movie record from another mode under low-light situation in
which the flash would fire while keeping shutter button is pressed halfway down.
3. Set the flash down once and up again. Flash stand-by mark doesn’t appear.
-----After the procedure 3. above, the flash fires and a still picture would be taten by
pressing shutter button fully.
6) After the card is got full by taking pictures at Panorama mode, Exif information of the picture
would be recorded as Panorama picture when still picture is taken after format or exchange the
card.
7) Focus incorrect under low-light situation when zoom is set to telephoto.
REMARKS : Update procedure
>Please refer to D-3 of Service Manual
Change classification
>Running change
OBJECT : All returned units from the market.
Rev.3
E-3Ver.1
Loading...