Oliver 6905 Owner's Manual

6905 Oscillating Spindle Sander

Owner’s Manual

Oliver Machinery M-6905 08/2017

Seattle, WA  Copyright 2003-2017
[e-mail] www.olivermachinery.net

TABLE OF CONTENTS

Table of contents _____________________________________________ 1

Safety rules __________________________________________________ 2

Specifications ________________________________________________ 3

Machine legend_______________________________________________3

Machine dimension ___________________________________________ 4

Safe operating position ________________________________________ 4

Instructions for operations _____________________________________

Tilting the table ______________________________________________ 5

Mounting spindle drum ________________________________________6

Selection guide for drum to table insert___________________________ 7

Maintenance of spindle sander __________________________________8

Troubleshooting ______________________________________________9

Assembly diagram ____________________________________________ 10

Parts List___________________________________________________ 11-13

5

2

SAFETY RULES

Read carefully before operating the machine

1. Learn the machine’s applications

and limitations, as well as the specific potential hazards

particular to this machine. Follow available safety instructions and safety rules carefully.

2. Keep working area clean and be sure adequate lighting is available.

3. Do not wear loose clothing, gloves, bracelets, necklaces, or ornament. Wear face, eye, ear,

respiratory and body protection devices, as indicated for the operation or environment.

4. Keep hands well away from sanding spindle and all moving parts. Do not clear sawdust
away with hands. Use a brush.

5. Make sure the spindles are moving at operation speed before sanding.

6. Do not push the sanding spindles to hard. The spindles will perform better and be safer

working at the rate for which it was designed.

7. Whenever possible use a dust collector with shaving hood to minimize health hazards.

8. Never leave the machine with the power on.

9. Keep children away. Make sure that visitors are kept at a safe distance from the work area.

10. Use recommended speed sanding accessory, and workpiece material.

11. Never stand on tool. Serious injury could occur if the tool is tipped or if the sanding tool is

unintentionally contacted.

12. Be sure sanding spindles are securely locked in the machine.

13. Use suitable support if stock does not have a flat surface.

14. Keep guards in place and in working order. If a guard must be removed for maintenance or

cleaning make sure it is properly attached before using the tool again.

15. Be sure that adjusting wrenches have been removed before turning power on.

16. Only use accessories designed for the machine. Use of accessories not recommended by

may result in a risk of injury.

17. Make sure tool is properly grounded. If tool is equipped with three-prong plug, it should be
plugged into a three-pole electrical receptacle. Never remove the third prong.

18. Always disconnect tool before servicing and when changing accessories such as spindle
sizes.

19. Hold material firmly against the table.

20. Do not use this spindle sander for other than it’s intended use. If used for other purposes,

disclaims any real or implied warranty and holds itself harmless for any injury, which may
result from that use.

3

SPECIFICATIONS

MODEL

6905.001

Table size (L x W)

14-1/2" x 14-1/2"

Table tilt 0~45°

Spindle speed 1400rpm

Oscillations per minute

29/min

Oscillation stroke

15/16"

Dust port diameter

2"

Motor

1/2HP/115V/1ph-only

MACHINE LEGEND

4

MACHINE DIMENSION

19"

SAFE OPERATING POSITION

14-1/2"

14-1/2"

28"

28"

28"

28"