Netgear VZCM2050, VZCB2010 Quick Start Manual

Adding a VueZone
Camera
Visit VueZone.com
NETGEAR, Inc.
350 East Plumeria Drive San Jose, CA 95134 USA
We’re here to help!
You can also access support by clicking the Help link when logged into your account at my.VueZone.com
?
What’s in the box
Mounting screw
VueZone Camera Camera mount
Battery
Install camera batteries
1
Go to http://support.netgear.com for support help.
Slide latch to remove
battery door.
Insert batteries as indicated
with negative terminal fi rst.
Replace battery door and latch.
©2013 NETGEAR, Inc. All rights reserved. NETGEAR, VueZone and the NETGEAR VueZone logo are trademarks or registered trademarks of NETGEAR, Inc. and/or its subsidiaries in the United States and/or other countries.
Night Vision Lamp
included only with
Night Vision Camera
Start viewing!
Synced cameras will appear on the Cameras tab on your account at my.VueZone.com.
Click on the camera or on the toolbar to start viewing.
4
Install cameras
3
Peel.
Remove strip from adhesive backing on mount. Do not remove if mounting on a screw.
Stick.
Press mount fi rmly on a fl at surface or hang from a screw.
Position.
Place the camera on the magnetic mount and aim.
Mounts for windows and tabletops/ceilings are also available at VueZone.com
Sync cameras
2
Click the Sync button on top of base station.
Blue Sync light will turn on.
Hold camera within 12 inches of the base station and slide power switch ON (green dot showing).
Blue light on camera front will blink for 5 seconds to confi rm sync.
NOTE: each time power is turned ON, motion detection cameras require 1 minute for sensor to warm up and operate.
Aim cameras from your smartphone with VueZone Mobile. For complete details, go to VueZone.com/mobileapps
Warning: Choking hazard with small parts. Keep out of reach of small children.
Declaration of Conformity
For the complete EU Declaration of Conformity, visit http://support.netgear.com/app/answers/detail/a_id/11621/
Loading...