NEC Display Solutions of America, Inc.
QIG-TMX4P-464UNV
X464UN-TMX4P, X464UNV-TMX4P Rev 1.1
Parts List
o (4) X464UN or X464UNV Displays
o (4) Onsite Service Warranties (ONSITEMN-3Y-14 or ONSITEMN-3Y-15)
o (4) Peerless Pullout Wall Mounts (DS-VW765-L13)
o (1) 25ft Cat5e Patch Cable
o (4) 3m DisplayPort 1.2 Cables
o (1) IR/Remote Control Kit (KT-RC2)
o (2) Overframe Bezel Kits (KT-46UN-OF2 or KT-46UN-OF3)
o (2) Tripp Lite 6 Outlet Strip (ISOBar6)
o (1) Display Wall Calibrator Kit (KT-LFD-CC)
NOTES:
o Any walls that this video wall solution is anchored to must be strong enough to support the displays and the
installation must be in accordance with any local building codes. All mounting apparatuses must make secure
contact to wooden studs.
o Please read entire document before starting installation
NEC Display Solutions of America, Inc.
QIG-TMX4P-464UNV
X464UN-TMX4P, X464UNV-TMX4P Rev 1.1
1. For mounting information, please refer to Installation Instructions provided by Peerless
Industries, Inc. inside the box of the DS-VW765-L13.
2. Connect the NEC display using the provided DisplayPort cables. Please note that in the
picture below, the IN connection is on the left and circled in red while the OUT connection is
on the right and circled in blue.
3. Connect the LAN cables that are located within the display box to daisy chain each display.
Note that the 25ft cat5e patch cable provided is optional and can be used for connecting the
source to display 1 within the wall. Note that in the picture below, LAN1 is on the left and
circled in red while LAN2 is on the right and circled in blue. LAN1 should be utilized as the
IN connection and LAN2 should be utilized as the OUT connection The LAN daisy chain
can be utilized to pass RS232C, IR Remote or TCP/IP information to each display down the
daisy chain.
4. Apply the OverFrame bezel kit to the video wall. Please follow instructions provided with kit.
KT-46UN-OF2 is utilized with the X464UN displays and KT-46UN-OF3 is utilized with the
X464UNV displays
Overframe Kit
2