Input level is expressed as the reading in open circuit
of 75-ohm source impedance signal generator
Usable sensitivity (999/1000 kHz) ≤ 60 dBμV
S/N Ratio (5 mV in) ≥ 38 dB
THD (5 mV in) ≤ 3 %
IF Rejection (450 kHz) ≤ 36 dB
Image Rejection (F+2xIF) ≥ 28 dB
Selectivity ≥ 17 dB
Output 170 -20/+30 mV
Loop sensitivity (20 dB S/N)
999/1000 kHz ≤ 66 dB
603/600 kHz ≤ 66 dB
1404/1400 kHz ≤ 66 dB
Frequency Response (100 - 2.3 kHz, 5 mV) ± 6 dB
FM TUNER SECTION *C *AH
Input level is expressed as the reading in open circuit
of 75-ohm source impedance signal generator
Usable sensitivity (98 MHz) ≤ 15 dBμ ≤ 15 dBμv
S/N Ratio (60 dB, IHF wtd) Mono ≥ 60 dB ≥ 60 dB
Stereo ≥ 63 dB ≥ 63 dB
Frequency Response (20 Hz - 15 kHz, 60 dBμ) 0 ± 1.5 dB 0 ± 1.5 dB
Channel Separation (60 dBμ) 100 Hz ≥ 30 dB ≥ 30 dB
1 k ≥ 32 dB ≥ 32 dB
10 kHz ≥ 30 dB ≥ 30 dB
Alternate Channel Selectivity (40 dBμ, ± 400 kHz) ≥ 60 dB ≥ 45 dB
Capture Ratio (40 dBμ) ≤ 3 dB ≤ 3 dB
AM Suppression (60 dBμ, 100% Mod. FM, 30% Mod. AM) ≥ 48 dB ≥ 48 dB
Image Rejection (119.4 MHz) − ≥ 65 dB
5
I.F. Rejection (10.7 MHz) ≥ 78 dB −
Pilot Suppression (98 MHz) ≥ 50 dB ≥ 50 dB
THD (60 dBμ, L=R 75 kHz for AH, 40 kHz Dev for C) Mono ≤ 0.5 % ≤ 0.5 %
Stereo ≤ 0.5 % ≤ 0.5 %
Auto-Search Sensitivity On ≥ 24 dBμ ≥ 24 dBμ
Off ≤ 15 dBμ ≤ 15 dBμ
RDS decode Sensitivity ≤ 26 dBμ −
PHYSICAL SPECIFICATIONS
Dimensions (Width x Height x Depth) 435 x 134 x 353 mm
Net Weight 9.45 Kg (20.79 lbs)
Shipping Weight 13.9 Kg (30.58 lbs)
6
REAR PANEL / FRONT PANEL VIEW
REAR PANEL
1. 7.1 CH INPUT
2. AUDIO PREOUT
3. MP DOCK
4. FM,AM ANTENNA INPUT
5. XM MODULE INPUT(AH)
DAB MODULE INOUT(C,CT)
6. RS-232
FRONT PANEL
7. +12V TRIGGER OUT
8. IR IN/OUT
9. AUDIO/VIDEO 1~6 IN
10. MONITOR(S-VIDEO,VIDEO)
11. AUDIO/VIDEO 3/4 OUT
12. ZONE 2,3,4
13. HDMI
14. DIGITAL AUDIO IN/OUT
15. COMPONENT IN/OUT
16. AC POWER INLET
17. SWITCHED AC OUTLET
18. POWER
1. POWER BUTTON
2. STANDBY LED
3. INFO
4. AM/FM/DB
5. TUNER MODE
6. MEMORY
7. NAVIGATION AND
ENTER BUTTON
8. VACUUM, FLUORES
CENT DISPLAY(VFD)
9. REMOTE SENSOR
10. VOLUME
11. SOURCE
7
12. LISTENING MODE
13. TONE CONTROLS
14. TONE DEFEAT
15. FRONT INPUT/MP
16. PHONES
17. FRONT INPUT JACKS
18. MP/MIC INPUT
DISASSEMBLY INSTRUCTIONS
1. Remove machine screws M4.0 x 8.0 (x6pcs) from the side panels.
Remove tapping screw 3.0 x 8.0 (x 4pcs) from the back panel.
Refer to Figure No. 1.
Figure No. 1
2. Pull both sides of the TOP COVER slightly outwards and tilt approx. 35 ° and then remove in the direction as indicated. Refer to Figure No. 2.
Factory Reset AH Source Down + Front/MP
Factory Reset C Source UP + Front/MP
Toggle IR Channel Source Down + Power Only for v1.08 or higher.
Check MCU Version Source Down + Source UP For v1.03 or higher, this checks all versions.
Check DSP Version Source Down + Listening Mode Only for v1.02 or older.
Check Current Video Mode Source Down + Tone Controls
MIC Test Source Down + Tone Defeat
VFD Test Source Down + Display
PAL/NTSC Source Down + Memory
DAB/XM Source Down + Tuner Band Must cycle power before change takes effect.
9k/10k Source UP + Tuner Band Must reselect AM before change takes effect.
XM 1kHz Test Tone Tuner Band + Tuner Mode XM must be selected first.
XM Signal Strength Tuner Mode for 0.5 seconds XM must be selected first.
XM Diagnostics Mode Tuner Mode for 3 seconds XM must be selected first.
Check DAB Module Version Tuner Mode for 3 seconds DAB must be selected first.
Enter Diagnostics Mode Source Down + Enter
Diagnostic Mode Down Source Down + Cursor Right
Diagnostic Mode Up Source Down + Cursor Left
Power Off All Zones Power Toggle or Power Off for 3 seconds