McIntosh VP1000 Guide

1A

120V
50/60Hz 50 WATTS

VP1000 Rear Panel Connections

Connect the VP1000 power cord
to a live AC outlet. Refer to infor­mation on the back panel of the
VP1000 to determine the correct
voltage for your unit

Provides H (Horizontal) and V
(Vertical) Synchronization Output
Signals required by some video
monitors (for use with the MONi­tor A Component Video Output)

COMPONENT OUTPUTS send
Component Video (Y, PR and PB)
Signals to Monitor A (Zone A) and
Monitor B (Zone B)

COMPONENT INPUTS receive
Component Video (Y, PR and PB)
Signals from six Component Video
Sources

MATRIX OUT provides a non-processed
Composite Video Signal from the selected
(1-6) Composite Inputs for Zone A and
Zone B

OUTPUT MONitor A and B send a
processed selected S-Video Signal
to a monitor located in Zone A and
Zone B

OUTPUT MONitor A and B send
a processed selected Composite
Signal to a monitor located in Zone
A and Zone B

INPUTS (1-6) for Composite
Video Signals from video source
components

DATA IN Ports for Zones
A and B allow the VP1000
to receive control data
from the Zones A and B
Sum Data Output Ports
on a McIntosh MX Series
A/V Control Center

IR INPUTS
for Zone A
and B external
sensors

POWER CONTROL
IN A and B receive a
tur n On/Off signal to
activate the VP1000
Zone A and/or Zone
B circuitry

POWER CONTROL
OUT A and B send
a tur n On/Off signal
to components for
Zones A and B

RS232 connector
for connection
to McIntosh
AP1000 or other
control device

Optical DIGITAL AUDIO
OUTput provides a Digital
Audio Signal from Zone A
selection of a HDMI Input

AUXILIARY OUTPUT HDMI
connector sends Zone A Selected
Digital Audio Signal to the McIn
tosh AP1000 Audio Processor. It
also mirrors the signal available at
the OUTPUT MONitor A HDMI
connector and can be connected
to a second monitor located in
Zone A.

INPUTS (1-6) for S-Video Signals
from video source components

INPUTS (1-4) for HDMI connectors
contain Digital Signals from video

-

OUTPUT MONitor A and B HDMI
connectors send Digital Signals to
a monitor located in Zone A and
Zone B

source components. The inter nal
LEDs indicate when an input has
been selected by Zone A or B and the
source component connected is active.

McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: [phone] FAX: [phone] Part No. 04101200

CV1
CV2
CV3
CV4
CV5
CV6

6 Composite

Inputs

6 Component

Inputs

6 S-Video

Inputs

4 HDMI

Inputs

HD1

HD2

HD3

HD4

1B

VP1000 Block Diagram

McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: [phone] FAX: [phone]