LINN BASIK LV-V
set-up manual
IMPORTANT CAUTION NOTES
==========================
The bearings used in the LV-V are of very high quality and are precisely adjusted. Care should be taken to insure that no unnecessary forces are applied to the bearings that might adversely affect the ir adjustment. We have detailed in the notes below some precautions that should be followed.
CAUTION NOTE l
To derive the best possible performance from this arm, it is necessary that the cartridge be mounted as firmly as possible to the headshell. This requires that a considerable amount of force be applied to the cartridge mounting screws. If this force is applied while the arm is mounted on the turntable, some of this force will be transmitted through the arm to the bearings and adversely affect their adjustment. To avoid this problem, after you have loosely mounted the cartridge end completed the alignments REMOVE THE DETACHABLE HEADSHELL FROM THE ARM, and then fully lighten the cartridge mounting screws. This eliminates the possibility of undue force being applied to the
arm bearings.
CAUTION NOTE 2
Never ship a turntable with the arm mounted on it. Always remove the arm and place it in its original packing. For short distances; i.e., transporting it across town in your car, you may leave the arm on the turntable. But be sure to remove 'the counterweight!
ARM MOUNTING INSTRUCTIONS
Note: These instructions are based on the assumption that the arm is being mounted on a Linn bonded LP12 turntable.
l) Mount the arm base on an armboard that has been cut as per the template on the last page of this manual.
NOTE: lf you are using an armboard drilled for the Linn Ittok LV-II tonearm you will
Loading...