Akurate 242
Important Safety Information
English
Important Safety Information
Explanation of symbols used in this manual and on the product:
This symbol is intended to alert the user to the presence of uninsulated
dangerous voltages within the enclosure of sufficient magnitude to cause
electric shock.
This symbol is intended to alert the user to the presence of important operation,
maintenance and servicing information in the instruction and service manuals.
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE THE COVER.
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
REPLACE THE MAINS FUSE IN THE PLUG WITH ONE OF THE SAME TYPE AND RATING.
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
SHOCK HAZARD. DO NOT OPEN.
MAINS PLUGS
This appliance is supplied with a non-rewireable mains plug for the intended country.
Replacement mains leads can be obtained from your Linn retailer. Should you need to
change the plug please dispose of it carefully. A plug with bared conductors is
dangerous if engaged in a live socket.
The Brown wire must be connected to the Live (Line) supply pin.
The Blue wire must be connected to the Neutral supply pin.
The Green/Yellow wire must be connected to the Earth (Ground) supply pin.
Please contact your retailer or a competent electrician if you are in any doubt.
GENERAL SAFETY INSTRUCTIONS
11.. RReeaadd iinnssttrruuccttiioonnss..
Read the safety and operating instructions before operating the appliance.
22.. RReettaaiinn iinnssttrruuccttiioonnss..
Retain the safety and operating instructions for future reference.
33.. HHeeeedd wwaarrnniinnggss..
Observe all warnings on the appliance and in the operating instructions.
44.. FFoollllooww iinnssttrruuccttiioonnss..
Follow all operating and use instructions.
55.. WWaatteerr aanndd mmooiissttuurree..
Do not use the appliance near water, for example near a bathtub, washbowl, kitchen
sink, laundry tub, in a wet basement, or near a swimming pool and the like.
66.. CCaarrttss aanndd ssttaannddss..
Use only with a cart or stand that is recommended by the manufacturer.
66aa..
An appliance and cart combination should be used with care. Quick stops, excessive force, and uneven
surfaces may cause the appliance and cart combination to overturn.
77.. WWaallll oorr cceeiilliinngg mmoouunnttiinngg..
Mount to a wall or ceiling only as recommended by the manufacturer.
88.. VVeennttiillaattiioonn..
Site the appliance so that its location or position does not interfere with its proper ventilation.
For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the
ventilation openings, or placed in a built-in installation such as a bookcase or cabinet that may impede the
flow of air through the ventilation openings.
99.. HHeeaatt..
Site the appliance away from heat sources such as radiators, heaters, stoves, or other appliances
(including amplifiers) that produce heat.
1100.. PPoowweerr ssoouurrcceess..
Connect the appliance to a power supply only of the type described in the operating
instructions or marked on the appliance.
1111.. GGrroouunnddiinngg oorr ppoollaarriissaattiioonn..
Do not defeat the safety purpose of the polarised or grounding type plug. A
polarised plug has two blades with one wider than the other. A grounding type plug has two blades and a
third grounding prong. The wide blade or the third prong is provided for your safety. When the provided plug
does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
1122.. PPoowweerr ccoorrdd pprrootteeccttiioonn..
Route power cords so that they are not likely to be walked on or pinched by items
placed upon or against them, paying particular attention to cords at plugs, power sockets, and at the point
where they exit from the appliance.
1133..MMaaiinnss pplluugg..
Use the mains plug to disconnect the product from the mains supply. The mains plug must be
accessible at all times. Use the mains switch (if applicable) when the product is not in use.
1144..CClleeaanniinngg..
The product should be cleaned only as recommended by the manufacturer.
1155.. PPoowweerr lliinneess..
An outdoor antenna should be located away from power lines.
1166..OOuuttddoooorr aanntteennnnaa ggrroouunnddiinngg..
If an outdoor antenna is connected to the tuner/receiver, ensure that the
antenna system is grounded to provide some protection against voltage surges and static build up. In the
USA see article 810 of the National Electrical Code ANSI/NFPA 70 concerning installation requirements.
1177.. LLiigghhttnniinngg ssttoorrmmss..
Unplug this apparatus during lightning storms or when unused for long periods of time.
1188.. OObbjjeeccttss aanndd lliiqquuiidd eennttrryy..
Do not let objects or liquids fall into the product. Do not expose the product to
dripping or splashing. Do not place a vessel containing liquid on top of the product.
1199.. DDaammaaggee rreeqquuiirriinngg sseerrvviiccee..
The product should be serviced by qualified personnel if:
a) The power cord or plug has been damaged.
b) Objects or liquid have fallen into the product.
c) The product has been exposed to rain.
d) The product does not appear to operate normally or exhibits a marked change in operation.
e) The product has been dropped or the enclosure damaged.
2200.. SSeerrvviicciinngg..
Do not attempt to service the product beyond that described in the operating instructions. All
other servicing should be referred to qualified service personnel.
i
AKURATE Loudspeaker System
Owner’s Manual
UK USERS PLEASE READ THIS
IMPORTANT SAFETY INFORMATION
Fuse replacement
This appliance is fitted with a non-rewireable 13 Amp mains plug. The plug contains a
5 Amp fuse. If the fuse has blown it can be replaced as follows:
a)Pull out the red fuse cover/carrier.
b)Remove and dispose of the blown fuse.
c)Fit a new 5 Amp BS1362 approved fuse into the carrier and push the carrier
back into the plug.
Always ensure the fuse cover is fitted. If the fuse cover is missing do not use the plug.
Contact your Linn retailer to obtain a replacement fuse cover.
Fuses are for fire protection and do not protect against electric shock.
Mains plug replacement
Should your mains plug need replacing and you are competent to do this proceed as
follows. If you are in doubt contact your Linn retailer or a competent electrician.
a)Disconnect the plug from the mains supply.
b)Cut off the plug and dispose of it safely. A plug with bared conductors is
dangerous if engaged in a live socket.
c)Only fit a 13 Amp BS1363A approved plug with a 5 Amp fuse.
d)The cable wire colours or a letter will be marked at the connection points of most
quality plugs.
Attach the wires securely to their respective points. The Brown wire must go to the Live
pin, the Blue wire must go to the Neutral pin, and the Green/Yellow wire must go to the
Earth pin.
e)Before replacing the plug top ensure that the cable restraint is holding the outer
sheath of the cable firmly and that the wires are correctly connected.
WARNING
THIS APPLIANCE MUST BE EARTHED.
CE Declaration of Conformity
Linn Products Ltd declare that this product is in conformance with the Low Voltage Directive 73/23/EEC and
Electromagnetic Compatibility 89/336/EEC as amended by 92/31/EEC and 93/68/EEC.
The conformity of the designated product with the provisions of Directive number 73/23/EEC (LVD) is proved by
full compliance with the following standards:
SSttaannddaarrdd nnuummbbeerr DDaattee ooff iissssuuee TTeesstt ttyyppee
EN60065 2002 General requirements
Marking
Hazardous radiation
Heating under normal conditions
Shock hazards under normal
operating conditions
Insulation requirements
Fault conditions
Mechanical strength
Parts connected to the mains supply
Components
Terminal devices
External flexible cords
Electrical connections and mechanical fixings
Protection against electric shock
Stability and mechanical hazards
Resistance to fire
The conformity of the designated product with the provisions of Directive number 89/336/EEC (EMC) is proved by
full compliance with the following standards:
SSttaannddaarrdd nnuummbbeerr DDaattee ooff iissssuuee TTeesstt ttyyppee
EN55013 2001 Conducted emissions
EN55013 2001 Absorbed emissions
EN55020 2002 Immunity
FCC notice
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
ii
Important Safety Information
English
AKURATE Loudspeaker System
Owner’s Manual
Copyright and Acknowledgements
Copyright © 2003 Linn Products Ltd. First edition July 2003.
Linn Products Limited, Glasgow Road, Waterfoot, Eaglesham, Glasgow, G76 OEQ,
Scotland, United Kingdom
All rights reserved. No part of this publication may be reproduced, stored in a retrieval
system, or transmitted, in any form or by any means, electronic, mechanical,
photocopying, recording, or otherwise, without the prior written permission of the
publisher.
Printed in the United Kingdom.
Trade marks used in this publication:
LLiinnnn
and the
LLiinnnn llooggoo
are registered trade marks
of Linn Products Limited.
AAKKUURRAATTEE
*,
AAKKTTIIVV,, SSEEKKRRIITT
and
SSKKEEEETTSS
are trade marks of
Linn Products Limited.
The information in this manual is furnished for informational use only, is subject to
change without notice, and should not be construed as a commitment by Linn Products
Limited. Linn Products Limited assumes no responsibility or liability for any errors or
inaccuracies that may appear in this manual.
* Patent pending
iii
AKURATE Loudspeaker System
Owner’s Manual
Copyright and Acknowledgements
English
Contents
Introduction 1
The AKURATE system 1
Feat ur es 2
AKURATE 242, 225 and 212 3
Unpacking 3
Fabric grilles 3
Cleaning 3
Positioning and levelling 4
Connecting 6
General 6
Single-wiring 7
Bi-wiring or bi-amping 7
Tri-wiring or tri-amping 7
Important notes on using the link strips 7
Quad-amping and beyond 7
Bass Boost 8
AKTIV operation 8
AKURATE 221 9
Unpacking 9
Voltage selection 9
Positioning 9
Fabric grille 9
Cleaning 9
Connecting 10
Operation 11
Operating modes 11
Parameters 11
Technical Specifications 13
Guarantee and Service 14
AKURATE Loudspeaker System
Owner’s Manual
Contents
English
Introduction
At Linn, we recognise that the way people access sound is changing.
Entertainment systems are becoming ever more integrated and the line
between music and movie systems is no longer clear. As the popularity of new
and improved hi-resolution music formats increases, multi-channel systems are
no longer for the movie enthusiast only.
As we change the way we access sound, the equipment we use to relay that
sound must also change. A modern loudspeaker must offer greater levels of
flexibility, reproduce a wider range of sounds and playback at a higher
resolution to truly communicate the full potential of the system. The
loudspeaker communicating the awesome force of an explosion in a movie
blockbuster must be subtle enough to replay the tone and emotion of the
softest female jazz vocal.
With this in mind, Linn presents AKURATE - a system of complementary
loudspeakers, visually and sonically designed to achieve seamless multi-channel
performance.
The AKURATE system
AAKKUURRAATTEE 224422
– A five-way, bass reflex, floorstanding loudspeaker, precision
engineered for use in medium to large sized listening areas. The AKURATE 242
speaker incorporates dual 6 1/2” (16.5 cm) drivers mounted vertically for
controlled, tuneful and extended bass performance.
AAKKUURRAATTEE 221122
– A compact, high-performance, four-way, bass reflex, bookshelf
loudspeaker. It features a single 6 1/2” (16.5 cm) bass driver and is designed for
use as a main speaker in smaller rooms or surround channel effects
applications. A custom designed stand is available for this model to allow
positioning for optimum performance.
AAKKUURRAATTEE 222255
– A centre channel loudspeaker designed primarily to match the
AKURATE 242 speakers. The AKURATE 225 speaker uses the same drive unit
complement as the AKURATE 242 speaker and has been tolerance-matched to
the other AKURATE loudspeakers to allow seamless system integration. A
custom designed stand is available for this model to allow positioning for
optimum performance.
AAKKUURRAATTEE 222211
– Bass extension in the AKURATE system is provided by the
powered 221 subwoofer. The unit is driven by a 500 W power amplifier and
features an 8” (20.3 cm) servo-controlled driver in a 21-litre enclosure for pure,
precise bass response.
1
AKURATE Loudspeaker System
Owner’s Manual
Introduction
English
Loading...