Explanation of symbols used in this manual or on the rear/underside of the
apparatus:
This symbol is intended to alert the user to the presence of uninsulated
dangerous voltages within the enclosure of sufficient magnitude to cause
electric shock.
This symbol is intended to alert the user to the presence of important
operation, maintenance and servicing information in the instruction and
service manuals.
For apparatus connected to the mains electricity supply
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
REPLACE THE MAINS FUSE IN THE PLUG WITH ONE OF THE SAME TYPE
AND RATING.
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE.
WWAARRNNIINNGG
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE. SHOCK HAZARD - DO NOT OPEN.
MMAAIINNSSPPLLUUGGSS
This apparatus is supplied with a non-rewireable mains plug for the intended
country. Replacement mains leads can be obtained from your Linn retailer.
Should you need to change the plug please dispose of it carefully. A plug with
bared conductors is dangerous if engaged in a live socket.
The Brown wire must be connected to the Live (Line) supply pin.
The Blue wire must be connected to the Neutral supply pin.
The Green/Yellow wire must be connected to the Earth (Ground) supply pin.
Please contact your retailer or a competent electrician if you are in any doubt.
Refer to the rear or underside of the product for fuse and power
consumption information.
location or position does not interfere with its proper ventilation. For
example, the apparatus should not be situated on a bed, sofa, rug, or
similar surface that may block the ventilation openings, or placed in a builtin installation such as a bookcase or cabinet that may impede the flow of
air through the ventilation openings.
A polarised plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong. The wide
blade or the third prong is provided for your safety. If the provided plug
does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.
when the apparatus has been damaged in any way, such as power-supply
cord or plug has been damaged, liquid has been spilled or objects have fallen
into the apparatus, the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
apparatus, ensure that the antenna system is grounded to provide some
protection against voltage surges and static build up. In the USA see article
810 of the National Electrical Code ANSI/NFPA 70 concerning installation
requirements.
Connect the apparatus to a power supply only of the type
Use the mains plug to disconnect the apparatus from the
An outdoor antenna should be located away from
If an outdoor antenna is connected to the
Do not connect the apparatus to a telephone line
Do not let objects or liquids fall into the
sshhoouullddbbee
piiccaall
UK USERS PLEASE READ THIS IMPORTANT SAFETY
INFORMATION
Fuse replacement
This appliance is fitted with a non-rewireable 13 amp mains plug. The plug
contains a 5 amp fuse. If the fuse has blown it can be replaced as follows:
a) Pull out the red fuse cover/carrier.
b) Remove and dispose of the blown fuse.
c) Fit a new 5 amp BS1362 approved fuse into the carrier and
push the carrier back into the plug.
Always ensure the fuse cover is fitted. If the fuse cover is missing do not use the
plug. Contact your Linn retailer to obtain a replacement fuse cover.
Fuses are for fire protection and do not protect against electric shock.
Mains plug replacement
Should your mains plug need replacing and you are competent to do this
proceed as follows. If you are in doubt contact your Linn retailer or a competent
electrician.
a) Disconnect the plug from the mains supply.
b) Cut off the plug and dispose of it safely. A plug with bared
conductors is dangerous if engaged in a live socket.
c) Only fit a 13 amp BS1363A approved plug with a 5 amp fuse.
d) The cable wire colours or a letter will be marked at the
connection points of most quality plugs.
Attach the wires securely to their respective points. The Brown wire must go to
the Live pin, the Blue wire must go to the Neutral pin, and the Green/Yellow wire
must go to the Earth pin.
e) Before replacing the plug top ensure that the cable restraint is
holding the outer sheath of the cable firmly and that the wires
are correctly connected.
WARNING
THIS APPLIANCE MUST BE EARTHED.
iiAKURATE 2200•3200•4200
CE Declaration of Conformity
Linn Products Ltd declare that this product is in conformance with the Low Voltage
Directive 73/23/EEC and Electromagnetic Compatibility 89/336/EEC as amended
by 92/31/EEC and 93/68/EEC.
The conformity of the designated product with the provisions of Directive number
73/23/EEC (LVD) is proved by full compliance with the following standards:
Marking
Hazardous radiation
Heating under normal conditions
Shock hazards under normal
operating conditions
Insulation requirements
Fault conditions
Mechanical strength
Parts connected to the mains
supply
Components
Terminal devices
External flexible cords
Electrical connections and
mechanical fixings
Protection against electric shock
Stability and mechanical hazards
Resistance to fire
The conformity of the designated product with the provisions of Directive number
89/336/EEC (EMC) is proved by full compliance with the following standards:
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Waste Electrical and Electronic Equipment (WEEE)
Directive
Directive 2002/96/EC of the European Parliament and of the Council
The symbol (right) is shown on this product. It indicates that the
product should not be disposed of with regular household waste,
but should be disposed of separately.
Electrical and electronic equipment can contain materials that are
hazardous to the environment and human health and therefore
should be disposed of at a designated waste facility or returned to
your retailer for the appropriate recycling to take place (see
www.linn.co.uk for further information).
If you wish to dispose of this product and the product still functions, please
consider recycling/reusing it by donating it to a charity shop, selling it or
part-exchanging it with your retailer.
Linn Products Limited, Glasgow Road, Waterfoot, Eaglesham,
Glasgow, G76 OEQ, Scotland, United Kingdom.
All rights reserved. No part of this publication may be reproduced,
stored in a retrieval system, or transmitted, in any form or by any
ENGLISH
means, electronic, mechanical, photocopying, recording, or otherwise,
without the prior written permission of the publisher.
The content of this manual is furnished for information use only, is
subject to change without notice, and should not be construed as a
commitment by Linn Products Limited. Linn Products Limited
assumes no responsibility or liability for any errors or inaccuracies that
may appear in this manual.
Trade marks used in this publication:
registered trade marks of Linn Products Limited.
CCHHAAKKRRAA,,AAKKTTIIVV
Limited.
Linn Products Limited disclaims any proprietary interest in trade
marks and trade names other than its own.
Printed in the United Kingdom.
Pack 1322
iv AKURATE 2200•3200•4200
, and
KKLLIIMMAAXX
LLiinnnn
are trade marks of Linn Products
and the
LLiinnnnllooggoo
AAKKUURRAATTEE,,
are
Contents
Introduction1
The AKURATE power amplifier range1
Features2
Installation3
Unpacking3
Positioning3
Connecting4
Connecting to the mains supply 4
Back panel connectors and switches 4
Back panels (Phono)5
Back panels (Balanced)6
Audio connections 7
Speaker terminals 8
Operation9
General9
Signal sensing9
Protection9
Technical Specifications10
Guarantee and Service 11
Channel Configuration Table 12
ENGLISH
vAKURATE 2200•3200•4200
Loading...
+ 15 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.