Kyocera FS-C2026, FS-2126MFP ServiceBulletin 2KW-0004-A273
BELT CLEANER ID
FEED ASSY
SHUTTER CLEANER ID
Service Bulletin Ref. No.
【【【【
Service information
】】】】
<Date> August 9, 2010
Subject Notes When Replacing the ID SENSOR ASSY
(Page.1/2)
2KW-0004 (A273)
Model
FS-C2026MFP, FS-C2126MFP
Topic
When replacing the ID SENSOR ASSY, please pay attention to the following.
<Notes on the Replacement of the ID SENSOR ASSY>
Please check the end of the BELT CLEANER ID is not bent when replacing the PARTS ID SENSOR ASSY SP.
(If the end of the BELT CLEANER ID is bent, the failure described below (1*) may occur.
As the measure against the BELT CLEANER ID end bending, the following change was made (2*).)
If the end of BELT CLEANER ID is bent, please put it back by pressing the bent part with a small finger or a small
screwdriver.
1*
Details of the Failure
When an end of the BELT CLEANER ID is bent, it is caught up by the GUIDE FEED and motion failure of the
SHUTTER CLEANER ID might occur.
That might cause an image density adjustment failure, color registration failure, etc. since calibration cannot be
correctly executed. (A calibration error occurs.)
<Position of ID SENSOR ASSY, SHUTTER CLEANER ID and BELT CLEANER ID>
Rear side
ID SENSOR ASSY
SHUTTER CLEANER ID
Press the end of the BELT
CLEANER ID to put it back.
When the primary transfer unit is taken out
KYOCERA MITA Europe B.V.
European Service & Development Center (ESDC)
Please check the end of the BELT
CLEANER ID.
Service Bulletin Ref. No.
【【【【
2*
Content of Change
The length of the BELT CLEANER ID was changed so that the BELT CLEANER ID will not be caught up by the
GUIDE FEED if an end of BELT CLEANER ID is bent.
KMC’s Classification
Field Measure: When replacing the ID SENSOR ASSY, please pay attention to the above.
Serial Nos. of the Affected Machines: After the stock of old parts is used up
Service information
[Change of the length]
From 3 mm to 1.8 mm
Entire Stock Rework In-Field modification at next visit
In-Field modification by case No modification necessary
(Page.2/2)
2KW-0004 (A273)
】】】】
<Date> August 9, 2010
European Service & Development Center (ESDC)
KYOCERA MITA Europe B.V.
Loading...