Kyocera FS-3040, FS-3140MFP Service Bulletin 2LW 013

Service Bulletin

SB Number:

SB 2LW-013

Creation Date: 06/12/2011

Firmware upgrade (Scanner v002.001 and Fax boot/APL

Subject:

v007.002)

Model: FS-3040MFP/3140MFP

Item Contents

1 Skipped parts of the

image on the print-out.

2 Solenoid motion failure. The DP reverse solenoid may not be released after completing Duplex scanning.

Phenomena

If the DP is closed during scanning of the original, when the copy job is started, while
opening the DP after placing the original on the contact glass, the following
phenomena may occur:

1. Only the leading edge of the image may appear on the print-out.

2. Only the trailing edge of the image may appear on the print-out.

This should not occur when copying with the DP.

Firmware

Type Program No. Check SUM Version Status Date Applicable model(s)

ENGINE 2LW_1000004001 6EAA 004.001 10/06/2011 FS-3040MFP/3140MFP

MAIN 2LW_2F00008003 ---- 008.003 ---------- FS-3040MFP

MAIN 2LX_2F00008003 ---- 008.003 ---------- FS-3140MFP

SCANNER 2LW_1200002001 ---- 002.001 10/06/2011 FS-3040MFP/3140MFP

FAX BOOT/APL 2H9_5500007002 ---- 007.002 ---------- FS-3140MFP

Note: Please upgrade all the rmware at the same time.

Classication

Field measure When the above mentioned phenomena occur, please upgrade the rmware to the latest

Serial numbers of affected machines

Type Serial number

FS-3040MFP/3140MFP October 2011 production.

The above mentioned changes have been applied to machines produced after the above mentioned production date.

Entire stock rework

version.

In-eld modication at next visit

In-eld modication by case

X

No modication necessary

KMIS Service Department, Kyocera Mita Europe B382 / SB 2LW-013

Page 1 of 1