Kyocera FS-3040, FS-3140MFP Service Bulletin 2LW 004

Service Bulletin

SB Number:

Subject:

SB 2LW-004

Failure to install the toner container in the machine

Creation Date: 30/09/2010

Model: FS-3040MFP/3140MFP

Phenomenon After removing the toner container from the packing material sideways, it may be impossible

to install the toner container in the machine, due to obstruction from the left side of the toner
container.

Cause The shutter gear leading edge gets behind the stopper of the toner container.

Solution 1. The shape of the shutter gear leading edge has been changed from 1.5mm to 2.5mm.

2. To prevent the possibility to remove the toner container sideways from the packing material,
the packing material has been changed.

Classication

Field measure When the above mentioned phenomenon occurs, please check if the shutter gear leading edge

Entire stock rework

is behind the stopper.

In-eld modication at next visit

In-eld modication by case

X

No modication necessary

Serial numbers of affected machines

Type Serial number

FS-3040MFP/3140MFP Not available

Toner container.

Old condition: The
leading edge of the
Shutter gear may be
stuck behind the stopper.

New condition: The
thickness of the leading
edge of the Shutter gear

has been changed.

Old thickness: 1.5mm.

Shutter gear Stopper

KMIS Service Department, Kyocera Mita Europe A266 / SB 2LW-004

Page 1 of 2

New thickness: 2.5mm.

Service Bulletin

Correct: Open the left and right aps on top of the
packing material and remove the toner container.

Wrong: When removing the toner container

sideways, the above mentioned phenomenon
may occur.

Old condition: The toner container can

be removed sideways.

Shutter gear and stopper.

New condition: The toner container can
not be removed sideways, due to the

added part.

KMIS Service Department, Kyocera Mita Europe A266 / SB 2LW-004

Page 2 of 2