English
Operating manual
Heating Immersion Circulator
ED
JULABO GmbH
77960 Seelbach / Germany
Tel. +49 (0) 7823 / 51-0
Fax +49 (0) 7823 / 24 91 info@julabo.de www.julabo.de
1.951.0266-V2 06/13
19510266-V2.doc |
11.07.13 |
Congratulations!
You have made an excellent choice.
JULABO thanks you for the trust you have placed in us.
This operating manual has been designed to help you gain an understanding of the operation and possible applications of our circulators. For optimal utilization of all functions, we recommend that you thoroughly study this manual prior to beginning operation.
The JULABO Quality Management System
Temperature control devices for research and industry are developed, produced, and distributed according to the requirements of ISO 9001 and ISO 14001 . Certificate Registration No. 01 100044846
Unpacking and inspecting
Unpack the circulator and accessories and inspect them for possible transport damage. Damage should be reported to the responsible carrier, railway, or postal authority, and a damage report should be requested. These instructions must be followed fully for us to guarantee our full support of your claim for protecting against loss from concealed damage.
The form required for filing such a claim will be provided by the carrier.
Printed in Germany |
Changes without prior notification reserved |
Important: keep operating manual for future use
2
ED
TABLE OF CONTENTS
Operating manual.................................................................................................................... |
4 |
|||
1. |
Intended use ................................................................................................................... |
4 |
||
|
1.1. Description.................................................................................................................. |
4 |
||
2. |
Operator responsibility – Safety recommendations......................................................... |
4 |
||
|
2.1. Disposal ...................................................................................................................... |
6 |
||
|
2.2. EC Conformity ............................................................................................................ |
7 |
||
|
2.3. Warranty conditions .................................................................................................... |
7 |
||
|
2.4. |
Technical specifications .............................................................................................. |
8 |
|
Operating instructions ........................................................................................................... |
10 |
|||
3. |
Safety notes for the user............................................................................................... |
10 |
||
|
3.1. Explanation of safety notes....................................................................................... |
10 |
||
|
3.2. Explanation of other notes ........................................................................................ |
10 |
||
|
3.3. Safety recommendations .......................................................................................... |
11 |
||
4. |
Operating controls and functional elements .................................................................. |
13 |
||
5. |
Preparations.................................................................................................................. |
14 |
||
|
5.1. |
Installation................................................................................................................. |
14 |
|
|
5.2. |
Bath fluids ................................................................................................................. |
15 |
|
|
5.3. Temperature application to external systems ........................................................... |
16 |
||
|
5.3.1. |
Pump set ........................................................................................................... |
16 |
|
|
5.4. Tubing....................................................................................................................... |
16 |
||
|
5.5. Adjusting the pump flow............................................................................................ |
17 |
||
|
5.6. Countercooling.......................................................................................................... |
18 |
||
6. |
Operating procedures ................................................................................................... |
19 |
||
|
6.1. Power connection ..................................................................................................... |
19 |
||
|
6.2. Switching on / Start – Stop........................................................................................ |
19 |
||
|
6.3. Automatic / non-automatic start mode ...................................................................... |
20 |
||
|
6.4. Setting the temperatures........................................................................................... |
21 |
||
|
6.5. Safety installations according to IEC 61010-2-010 ................................................... |
21 |
||
|
6.5.1. |
Excess temperature protection.......................................................................... |
21 |
|
|
6.5.2. Low liquid level protection ................................................................................. |
21 |
||
7. |
Troubleshooting guide / Error messages ...................................................................... |
22 |
||
8. |
Cleaning / repairing the unit .......................................................................................... |
23 |
||
3
Operating manual
Operating manual
1.Intended use
JULABO circulators have been designed to control the temperature of specific fluids in a bath tank.
JULABO circulators are not suitable for direct temperature control of foods, semiluxury foods and tobacco, or pharmaceutical and medical products. Direct temperature control means unprotected contact of the object with the bath medium (bath fluid).
1.1.Description
The circulators are operated via the splash-proof keypad. The implemented microprocessor technology allows to set and to store the setpoint that can be indicated on the LED temperature display.
The PID temperature control adapts the heat supplied to the thermal requirements of the bath.
Safety installations conforming to IEC 61010-2-010
PID1 |
The excess temperature protection is a safety installation independent from |
|
the control circuit. |
||
|
||
|
The safety value is set using a tool (screwdriver). |
|
|
||
|
If the low level protection device is triggered, a complete shutdown of the |
|
|
heater and circulating pump is effected. |
2.Operator responsibility – Safety recommendations
The products of JULABO ensure safe operation when installed, operated, and maintained according to common safety regulations. This section explains the potential dangers that may arise when operating the circulator and also specifies the most important safety precautions to preclude these dangers as far as possible.
4
ED
Persons:
The operator is responsible for the qualification of the personnel operating the units.
The operator should be constantly informed about the dangers involved with their job activities as well as preventive actions.
Make sure all persons expected to carry out operation, installation and maintenance of the unit read and understand the safety information and operating instructions.
If you have any questions concerning the operation of your unit or the information in this manual, please contact us!
Contact |
JULABO GmbH |
Tel. |
+49 (0) |
7823 / 51-0 |
|
Eisenbahnstraße 45 |
Fax |
+49 (0) |
7823 / 24 91 |
|
77960 Seelbach / Germany |
info@julabo.de |
||
|
|
www.julabo.de |
||
Handling:
Nevertheless, avoid strikes to the housing, vibrations, damages to the keypad foil (keys, display) or contamination.
Make sure the product is regularly checked for proper condition.
Regularly check (at least every 2 years) the proper condition of the mandatory, warning, prohibition and safety labels.
Take care that the mains supply features a low impedance to avoid any negative affects on the instrument being operated in the same mains.
This unit is designed for operation in a controlled electromagnetic environment. This means that transmitting devices (e.g. cellular phones) should not be used in the immediate vicinity.
Magnetic radiation may influence other units with components susceptible to magnetic fields (e.g. a monitor). We recommend to keep a minimum distance of 1 m.
Permissible ambient temperature: max. 40 °C, min. 5 °C.
Permissible relative air humidity: 50 % (40 °C).
Do not store in an aggressive atmosphere. Protect from contaminations.
Do not expose to sunlight.
Appropriate operation:
Only qualified personnel is authorized to perform configuration, installation, maintenance and repairs of the circulator.
Routine operation can also be carried out by untrained personnel who should however be instructed by trained personnel.
Use:
The bath may not be filled with flammable materials. Fire hazard!
Only use recommended materials (bath fluids). Only use recommended materials (bath fluids).
Only use non-acid and non corroding materials.
5
Operator responsibility – Safety recommendations
When using hazardous materials or materials that could become hazardous, the operator must affix the enclosed safety labels (1 + 2) to the front of the unit so they are highly visible:
1 |
Warning label W00: |
Colors: yellow, black |
|
Danger area. Attention! Observe instructions. |
|
|
(operating manual, safety data sheet) |
|
|
|
|
2 |
Mandatory label M018: |
Colors: blue, white |
|
Carefully read the user information prior to beginning operation. |
|
or |
Scope: EU |
|
|
|
|
2 |
Semi S1-0701 Table A1-2 #9 |
|
|
Carefully read the user information prior to beginning operation. |
|
|
Scope: USA, NAFTA |
|
|
|
|
Particular care and attention is necessary because of the wide operating range.
There are thermal dangers:
Burn, scald, hot steam, hot parts and surfaces that can be touched.
Warning label W26: Colors: yellow, black
Hot surface warning.
(The label is put on by JULABO)
2.1.Disposal
Do not dispose of the unit with household waste!
However, over the long operating period of the unit, disposal rules may change. Therefore, only qualified personnel should handle the disposal.
Valid in EU countries
See the current official journal of the European Union – WEEE directive.
Directive of the European Parliament and of the Council on waste electrical and electronic equipment (WEEE).
This directive requires electrical and electronic equipment marked with a crossed-out trash can to be disposed of separately in an environmentally friendly manner.
Contact an authorized waste management company in your country. Disposal with household waste (unsorted waste) or similar collections of municipal waste is not permitted!
6
ED
2.2.EC Conformity
The products described in the operating instructions conform to the requirements of the following European guidelines:
Directive of the European Parliament and of the Council on the approximation of the laws of the Member States relating to machinery.
EMC guideline with respect to legal harmonization of the member countries concerning electromagnetic compatibility.
JULABO GmbH
Eisenbahnstr. 45
77960 Seelbach / Germany
2.3.Warranty conditions
JULABO GmbH warrants its products against defects in material or in workmanship, when used under appropriate conditions and in accordance with appropriate operating instructions
for a period of ONE YEAR.
Extension of the warranty period – free of charge
With the ‘1PLUS warranty’ the user receives a free of charge extension to the warranty of up to 24 months, limited to a maximum of 10 000 working hours.
To apply for this extended warranty the user must register the unit on the JULABO web site www.julabo.de, indicating the serial no. The extended warranty will apply from the date of JULABO GmbH’s original invoice.
JULABO GmbH reserves the right to decide the validity of any warranty claim. In case of faults arising either due to faulty materials or workmanship, parts will be repaired or replaced free of charge, or a new replacement unit will be supplied.
Any other compensation claims are excluded from this guarantee.
7
Loading...