John Deere QRG 2680H User Manual

QRG 2680H
NOTE: Use this as a reference guide. For further details on procedures, see the Operator’s Manual provided with the machine.
Quick Reference Guide
Connect Hydraulics
IV
SCV Function
I Front Wheel Lift
II Rear Roller Lift
III Main Frame Lift
IV Wings
III
V Hitch Jack Lift
VI Optional Scraper
IMPORTANT: If proper responses are not observed during folding or unfolding procedure, see Make Proper Hose Connections in the Operator’s Manual.
II
I
IV
II
I
Engine Horsepower Requirements
Machine Size Tractor Power
16 ft 220 hp Minimum
18 ft 250 hp Minimum
21 ft 290 hp Minimum
24 ft 340 hp Minimum
Engine horsepower requirements may vary depending on soil conditions and digging depth.
1. Remove transport lock pins (A) from the cradles and place in storage location.
2. Extend SCV III until wings clear the cradles.
A
3. Extend SCV IV to unfold the wings.
4. Place both SCV III and SCV IV into the FLOAT position to lower the machine.
Folding Sequence
A. Take SCV III and SCV IV out of the
FLOAT position and retract SCV III until wing is perpendicular to the ground.
B. Retract SCV IV to fold wings inward
until touching inner edge of cradles.
C. Retract SCV III until resting in cradles.
D. Insert and lock transport pins in place.
Adjust Operating Depth
QRG 2680H
To adjust depth, raise wheel
cylinders (A) and basket cylinders (B).
Add cylinder stops for
shallower depth.
Remove stops for deeper
depth.
Quick Reference Guide
B
A
In-Field Operation
Ensure SCV III (Main Frame Lift) and SCV
IV (Wings) are in the FLOAT position.
Adjust operating speed between 10 to
14 mph.
For headland turns, make skip row
passes at the desired operating depth.
Ensure a minimum of 6 to 8 inches
overlap.
IMPORTANT: Do not reverse machine in ground or damage may occur.
Do not use SCV III (Main Lift) during reversals and turns.
Do not make sharp turns causing tires to contact the hitch.
Copyright © 2018 Deere & Company. All Rights Reserved. THIS MATERIAL IS THE PROPERTY OF Deere & Company. ALL USE AND OR REPRODUCTION NOT SPECIFICALLY AUTHORIZED BY Deere & Company IS PROHIBITED.
All information, illustrations, and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice.
When backing up, raise the machine
using SCV I and SCV II. If machine is equipped with the rubber roller attachment, raise the scraper using SCV VI.
Machine Setting Fall Tillage Spring Tillage
Depth 3.5—4.5 in 2—3 in
Soil Deflector Storage Position (High Residue) Engaged Position (Low Residue)
Soil Deector (Storage Position) Soil Deector (Engaged Position)
QRG1624B01R (30NOV18) Printed in U.S.A.
Loading...