Intel NUC Kit D54250WYKH & D34010WYKH User Guide
Intel® NUC Kit D54250WYKH
Intel® NUC Kit D34010WYKH
User Guide
1
Intel NUC Kit D54250WYKH & D34010WYKH User Guide
Before You Begin
CAUTIONS
The procedures in this user guide assume familiarity with the general terminology associated with personal computers and with the safety practices and regulatory compliance required for using and modifying electronic equipment.
Disconnect the computer from its power source and from any telecommunications link or network before performing any of the procedures described in this guide. Failure to disconnect power, telecommunications links, or networks before you open the computer or perform any procedures can result in personal injury or equipment damage. Some circuitry on the board can continue to operate even though the front panel power button is off.
Follow these guidelines before you begin:
Always follow the steps in each procedure in the correct order.
Set up a log to record information about your computer, such as model, serial numbers, installed options, and configuration information.
Electrostatic discharge (ESD) can damage components. Perform the procedures described in this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam pad. If such a station is not available, you can provide some ESD protection by wearing an antistatic wrist strap and attaching it to a metal part of the computer chassis.
Installation Precautions
When you install and test the Intel NUC, observe all warnings and cautions in the installation instructions.
To avoid injury, be careful of:
Sharp pins on connectors
Sharp pins on circuit boards
Rough edges and sharp corners on the chassis
Hot components (such as SSDs, processors, voltage regulators, and heat sinks)
Damage to wires that could cause a short circuit
Observe all warnings and cautions that instruct you to refer computer servicing to qualified technical personnel.
Observe Safety and Regulatory Requirements
If you do not follow these instructions, you increase your safety risk and the possibility of noncompliance with regional laws and regulations.
2
Intel NUC Kit D54250WYKH & D34010WYKH User Guide
This guide tells you how to:
•Install and remove memory
•Install a wireless card
•Install an mSATA SSD
•Install a 2.5” drive
•Install a VESA mount bracket
•Install an operating system
•Install the latest drivers
Open the Intel NUC Chassis
To open the Intel NUC chassis, follow these steps:
1. Unscrew the four corner screws on the bottom cover of the chassis and lift the cover.
3
Intel NUC Kit D54250WYKH & D34010WYKH User Guide
2. Lift up the hard drive bracket and set it over the edge of the chassis to expose the motherboard.
Installing and Removing Memory
Intel NUC Kits D54250WYKH and D34010WYKH have two 204-pin DDR3L SO-DIMM sockets. Memory requirements:
1.35V low voltage memory
1333 MHz or 1600 MHz SO-DIMMs
Non-ECC
For a list of tested memory, go to the System Memory page on the Support site:
System Memory for Intel NUC Kit D54250WYKH
System Memory for Intel NUC Kit D34010WYKH
Install SO-DIMMs
If you plan to install just one SO-DIMM, install it in the upper memory socket.
To install the SO-DIMMs, follow these steps:
1.Observe the precautions in "Before You Begin" on page 2.
2.Turn off all peripheral devices connected to the computer. Turn off the computer and disconnect the AC power cord.
4
Loading...