Membrane-covered
vent
Level
Aqua
MP
TROLL®
TROLL
TROLL
Accessories
®
Accessories
®
9500 Accessories
Information Sheet
Catalog No. 0052230
SMALL DESICCANT
APPLICATION
A disposable cap that provides cable venting, a hydrophobic water barrier
membrane, and indicating desiccant to protect vented RuggedCable™ and
instrument electronics from condensation of water vapor.
Mating pin
O-ring
Protect new desiccant from
moisture until ready to use.
Indicating desiccant is blue when
dry. It gradually turns pink as it
becomes saturated.
Twist-Lock
connector
PHYSICAL DESCRIPTION
Materials ABS plastic, HDPE membrane (high density
polyethylene)
Dimensions 18 mm (0.7 in) O.D., 5.3 cm (1.2 in) long
Environmental rating IP 67 (15 cm - 1 m for 30 minutes)
Desiccant Silica gel, type 4
Particle size 0.5 – 1.0 mm bead
Indicating dye Cobalt chloride, 0.5%
INSTALLATION
1. If necessary, remove the used desiccant—the gel will look pink or white—from
the cable by grasping the knurled (textured) section of the cable connector in one
hand and the desiccant in the other. Twist in opposite directions to unlock the
desiccant connector from the cable connector.
2. Attach the new desiccant to the cable.
Attaching cables or accessories is a simple matter of mating the TwistLock connectors. This is easy after you've done it once or twice. For
detailed steps and photographs, see the Product Quick Start Guide, or
refer to the Operator's Manual located on the software CD.
1 800 446 7488
(toll-free, US and Canada) or 970 498 1500 www.in-situ.com
Due to continuing product development this information is subject to change without notice. In-Situ and the In-Situ logo, Win-Situ, TROLL, BaroTROLL,
RuggedReader, RuggedCable, and RDO are trademarks or registered trademarks of In-Situ Inc. Copyright © 2006 by In-Situ Inc. All rights reserved.
0052232 rev. 001 10/06
Loading...