Huawei MU203B Installation Manual

Copyright © 2009 Huawei Technologies Co., Ltd.

All Rights Reserved

No part of this document may be reproduced or transmitted in any form or by any
means without prior written consent of Huawei Technologies Co., Ltd.

Trademarks and Permissions

and other Huawei trademarks are trad emarks of Huawei T echnolo gies Co. ,

Ltd.
All other trademarks and trade names mentioned in this document are the

property of their respective holders.

Notice

The information in this document is subject to change without notice. Every effort
has been made in the preparation of this document to ensure accuracy of the
contents, but all statements, information, and recommendations in this document
do not constitute the warranty of any kind, express or implied.

Table of Contents

Getting to Know the MU203..................................................................... 1

Preparing the MU203.............................................................................. 4

Installation Guide .................................................................................. 5

Safety Information................................................................................. 9

i

Thank you for purchasing Huawei MU203 Wireless
Module.

Note:

 This manual briefly describes the preparation, the process for

installing/uninstalling, and safety precautions for using Huawei MU203
Wireless Module (hereinafter referred to as the MU203).

 You are recommended to read the manual before using the MU203.
 The signal strength and the transmission rate are affected by the actual

environment.

Getting to Know the MU203

The following figure shows the appearance of the MU203. The actual product may
differ.

1

2

3

1

2

2

n BTB Connector

It is used to connect to the interface of the PC.

o Screw holes

They are used to fix the MU203 on the main board of the PC with screws.

p Antenna interfaces

It is used to connect an antenna.

Requirements for the User Side

To use the MU203, the user must meet the following requirements:

2

 60-pin Board to Board Connector interface.
 Windows CE/Windows XP/Linux 2.6.18 or later versions
 Display resolution: 800 × 600 or above.
 The antenna gain：850M<4.28dBi，1900M<2.1dBi

3