Hp LASERJET M2727 MFP Copy Manual

HP LaserJet M2727 MFP Series – Copy

Copy using the automatic document feeder (ADF)

How do I? Steps to perform

1 Insert the top-end of the stack of originals into the

Load originals using the automatic document feeder (ADF)

CAUTION: To prevent damage to the product, do not use

an original that contains correction tape, correction fluid, paper clips, or staples. Also, do not load photographs, small originals, or fragile originals into the ADF. Use the flatbed glass to scan these items.

3 Adjust the media guides until they are snug against

automatic document feeder input tray, with the media stack face-up and the first page to be copied on top of the stack.

2 Slide the stack into the ADF until it does not move any

farther. Document loaded appears on the controlpanel display.

the media.

Document loaded

4 Press Start Copy on the product control panel to start

copying.

1

www.hp.com

HP LaserJet M2727 MFP Series – Copy

Copy using the flatbed scanner

How do I? Steps to perform

1 Make sure that the automatic document feeder (ADF)

Load originals in a flatbed scanner

2 Place the original document face-down on the flatbed

3 Gently close the lid.

contains no media. Lift the flatbed scanner cover.

scanner with the upper-left corner of the document at the corner indicated by the icon on the scanner.

4 Press Start Copy on the product control panel to start

copying.

1

www.hp.com

HP LaserJet M2727 MFP Series – Copy

Collate my copy job

How do I? Steps to perform

1 On the product control panel, press Collate.

Change the copy-collation setting for the current job

2 Use the arrow buttons to select On and Off.

On

3 Press Start Copy to save the selection and

immediately start the copy job, or press OK to save the selection without starting the job.

1

www.hp.com