Honeywell CN85L0N User Manual

Install the Battery

1

2

3

The CN85 mobile computer ships with a Li-ion 3.85 VDC, 22.3
watt-hour battery manufactured for Honeywell International
Inc.

Use only Honeywell Li-ion battery pack model
CW-BAT.

Ensure all components are dry prior to placing the
battery in the computer. Mating wet components may
cause damage not covered by the warranty.

7

Install the Hand Strap

1

2

43

5

Snap

Snap

8

Charge the Mobile Computer

The CN85 mobile computer ships with a partially charged
battery. Charge the battery with a CX85 Series charging device
for a minimum of 4 hours. Using the computer while charging
the battery increases the time required to reach a full charge.

We recommend the use of Honeywell accessories and
power adapters. Use of any non-Honeywell
accessories or power adapters may cause damage not
covered by the warranty.

CN85 mobile computers are designed for use with the following
CX85 Series charging accessories: Home Base, Ethernet Home
Base, Charge Base, Net Base, Quad Battery Charger, Vehicle
Power Adapter, Vehicle Dock, and Snap-on Adapters.

Ensure all components are dry prior to mating the
computers and batteries with peripheral devices.
Mating wet components may cause damage not
covered by the warranty.

9

Turn Power On/Off

The first time you power on the computer, a Welcome screen
appears. You can either scan a configuration bar code or use the
Wizard to manually set up the computer. Once setup is
complete, the Welcome screen no longer appears on startup
and Provisioning mode is automatically turned off (disabled).

To turn the computer on:

•Press and hold the Power button for approximately 3 seconds,
and then release.

To turn the computer off:

1. Press and hold the Power button until the options menu

appears.

2. Touch Power off.

Swap Battery Mode for Battery Replacement

You should always place the computer in Swap Battery mode
before removing the battery. Swap Battery mode places the
computer in a low power state so that the battery can be
removed for a short time.

To activate Swap Battery mode:

1. Press and hold the Power button until the options menu

appears.

2. Touch Swap Battery and follow the on-screen instructions.

3. Once you replace the battery, press the Power button.

10