Hewlett Packard X3K01AA Quick Start Guide
Installation Instructions
NOTE: If you need help preparing your computer model
for this installation, refer to the documentation provided
with the computer, or go to www.hp.com/support to
locate the manual for your model.
Installing the LCD
You must install the LCD in the top USB port on the RP9 display
head. Before installing the LCD, you must remove the display
head rear cover and the top port cover.
1. Press the two latches on the display head rear cover
outward 1. Slide the rear cover up, and then lift it off the
display head 2.
3. Insert the USB connector on the LCD module into the top
USB port 1, and then secure the module with the two
screws that were previously removed 2.
© Copyright 2016 HP Development Company, L.P.
The information contained herein is subject to change without
notice.
Printed in
First Edition: June 2016
*843783-001*
843783-001
Before you begin
1. Turn off the computer properly through the
operating system, and turn off any external devices.
2. Disconnect the power cord from the AC outlet and
disconnect any external devices.
WARNING! To avoid the risk of serious injury or
damage to the system, ensure that the power cord
is unplugged from the AC outlet at the wall before
installing this product. Failure to do so may expose
you to the risk of electric shock.
NOTE: For regulatory and safety notices, refer to
the Product Notices included with your product.
2. Remove the two screws that secure the top port cover 1,
and then pull the port cover off the display head 2.
NOTE: You may need to gently loosen the port cover
from inside the screw holes with a flat-bladed
screwdriver.
4. Align the tabs on the display head rear cover with the
slots on the display head. Place the cover on the display
head, and then slide the cover down so that it snaps into
place.
5. Reconnect the power cord and any external devices, and
then turn on the computer.
Documentation feedback
HP is committed to providing documentation that meets your
needs. To help us improve the documentation, please send any
suggestions, comments, or errors to doc.feedback@hp.com.
Include the document title and part number (located near the
barcode) when submitting your feedback.
Product support
For online access to technical support information, selfsolve tools, online assistance, community forums or IT
experts, broad multivendor knowledge base, monitoring
and diagnostic tools, go to
www.hp.com/support.
Loading...