Henny Penny PFE-591 Installation Manual

Model PFE- 591

SECTION 2. INSTALLATION

2-1. INTRODUCTION

This section provides the installation and unpacking

instructions for the Henny Penny Model PFE-591.

Installation of this unit should be performed only by a
qualifi ed service technician.

Do not puncture the fryer with any objects such a

drills or screws as electrical shock or component
damage could result.

2-2. UNPACKING

INSTRUCTIONS
Note any shipping damage in the presence of the delivery

agent and signed prior to his or her departure.

1. Cut and remove the plastic bands from the main box.

2. Remove the box lid and lift the main box off the fryer.

3. Remove corner packing supports (4).

4. Cut the stretch fi lm from around the carrier/rack box and
remove it from the top of the fryer lid.

5. Cut and remove the metal bands holding the fryer to the
pallet.

All counterweights must be loaded before unlatching

the lid, or personal injury could result.

6. Remove the fryer from the pallet.

Take care when moving the fryer to prevent personal

injury. The fryer weighs approximately 758 lbs.
(344 Kg).

2-1 803

Model PFE- 591

2-2. UNPACKING

7. Remove the counterweights from the pallet, which are
INSTRUCTIONS

strapped to the pallet, under the fryer.

(Continued)

Do not drop. The counterweights weigh approximately
18 lbs. (8.1 kg.) each. Handle with care, or personal
injury could result.

8. Remove rear cover.

9. Load the seven weights into the counterweight assembly.
See page 2-4.

10. Replace rear cover.

11. Cut warning tags from the lid assembly. The lid may now
be unlatched.

12. Remove the accessories from inside the fi lter drain pan.

13. Prepare the deadweight valve for operation

The metal packing spacer is placed inside the deadweight
valve housing to protect the deadweight orifi ce and dead-
weight during shipment. Remove this packing spacer
prior to installation, in order to build pressure.

A. Unscrew the deadweight cap.

B. Remove the deadweight.

C. Remove and discard the metal packing spacer.

D. Clean the deadweight orifi ce with a dry cloth.

E. Carefully place deadweight over deadweight orifi ce.
Replace deadweight cap, fi nger tight.

14. Remove the protective paper from the fryer cabinet.

Clean exterior surface with a damp cloth.

404 2-2

Model PFE- 591

Optional Ramp Unloading

2-3 403