Henny Penny OE-303, OE-301, OE-302, OG 301, OG 303 User Manual

...
The controls have four programming levels, a first level mode, a second level mode, a third level mode, and a special program mode. In each level, pressing the set switch advances through the programmable items. Program mode can be entered at anytime except during an alarm. The left display describes the item being programmed. The right display shows the item set­ting and can be changed by pressing the right Up and Down Switches.
1. Press and hold Set and Temperature Switch for at least five seconds. A tone will sound, and the left display shows
“OF” and the right display shows the set point temperature.
The temperature LED and all product indicator LED’s flash.
2. Press the right Up and Down Switches to program desired set point temperature for all products.
3. Press the set switch and left display shows “Slct” and the right display shows “Prod”. The product LED also flashes.
4. Press either the left or right Up and Down Switches to select a product to program, and the LED will be lit next, to the desired product.
5. Press the set switch and the time LED flashes. The left displays shows “Fry” and the right display shows the cook time. Pressing the right Up and Down Switches adjusts the cook time.
6. Press the set switch and the time LED continues to flash. The left display shows “Hold,” the right display shows the hold time and can be adjusted with the right Up and Down
Switches.
7. Press the set switch and the alarm LED flashes. The left display shows “AL 1”) the right display shows the alarm time and can be adjusted with the right Up and Down Switches.
8. Repeat step 8 for alarms 2,3, and 4.
9. Press and hold the Set Switch to exit program mode, or continue to second level mode.
The Second Level Program Mode allows the operator to pro­gram load compensation, load anticipation, proportional control, filter cycle for the selected product, and the idle parameters.
1. While in the first level mode, push and hold the Set and Exit Melt Switches for five seconds. The beeper will sound
the left display will show “Slct” (Select) and the right display will show “Prod” (Product). The Product LED also flashes.
2. Press either the right or left Up and Down Switches to select a product to program.
3. Press Set Switch and the Other LED flashes. The left display shows “LdCo,” and the right display shows load compen­sation setting, and can be adjusted with the right Up and
Down Switches.
4. Press the Set Switch and the Other LED continues to flash.
The left display shows “PC,” the right display shows the
proportional control setting, and can be adjusted with the
right Up and Down Switches.
5. Press the Set Switch and the Other LED continues to flash. The left display shows. “LdAn,” and the right display shows load anticipation setting, and can be adjusted with the right Up and Down Switches.
6. Press the Set Switch and the Other LED continues to flash. The left display shows “Filtr,” and the right display shows filter cycles setting, and can be adjusted with the right Up and Down Switches.
7. Press the Set Switch and the Product LED flashes. Press
~
either right or left Up and Down Switches to select another product to program. Press and hold the Set Switch to exit the
program mode, or continue on to the third level program mode.
Loading...
+ 2 hidden pages