Henny Penny OG 301, OG-302, OG-303, OE-301, OE-302 User Manual

This section provides troubleshooting information in the form of
an easy-to-read table.

If a problem occurs during the first operation of a new fryer,
recheck the installation per Section 2 of this manual.

Before troubleshooting, always recheck the operating procedure
per Section 3 of this manual.

e

T

LES

In the event of a control system failure, the digital display will

show an “Error Message.” These messages are coded: E5, E4, E6,
ElO, E15, E41, E50, E51, and E53.

en turn

switc
display shows E4, the control board is getting too hot. Check the
louvers on each side of the unit for obstuctions. If E4 persists,

Turn switch to OFF position, then turn switch back to ON. If
display shows E6, thermal sensor must be replaced. Refer to
section 6-4.

El5

E41, E50,
E5 1, E53

button. If high limit does not reset, high limit must be replaced
per section 6-5, or 6-6.

Drain Switch Close drain, using the drain valve handle. If display still shows
Failure

E 15 check drain valve section 6- 13.

Programming Turn switch to OFF, then back to ON. If display shows any of
Failure the error codes, the control panel needs replaced.

LE

NG

With switch in
POWER position
and switch light
not illuminated,
fryer is complete
ly inoperative.

With switch in
power position,
switch light is
on, but all other
lights are out ex
cept the pump
will operate.

Shortening will
not heat but
lights are on.

Open Circuit

No power to
board

Faulty Contactor
(elec. model)

Check to see if unit is plugged in.
Check breaker or fuse at supply box.
Check control panel fuse per Section 6-12.

@ Check POWER switch per Section 6-14. Replace if defective.

.Check voltage at wall receptacle.

Check cord and plug.

Check fuse on PC board.

Faulty Gas Valve
(gas model)

Faulty Gas
Solenoid (gas

model)

Faulty Probe

Faulty High
Limit

Faulty Drain
Switch

Check gas valve per Section 6-11.

Check gas solenoid, per Section 6-19.

Check probe per Section 6-4. “Error message” E6.

Check High Limit per Section 6-6, or 6-7. “Error message”
ElO.

Check drain switch per Section 6-13. “Error message” E15.