®
Automatic Ice Maker
Machine à
Glace Automatique
Fabricador de Hielos Automático
Installation Instructions-
Model #
Instructions d'installation-
HI1MK
Modèle #
Instrucciones de instalación-
Modelo #
English
Important Safety Instructions
Warning!
1)To avoid electric shock, which can cause death or severe personal injury, disconnect the refrigerator from the electrical power before connecting a water supply line to the refrigerator.
2)Do not place fingers or hand on the automatic ice making mechanism while the refrigerator is plugged in. This will help protect you from possible injury. It will also prevent interference with moving parts of the ejector mechanism and the heating element that releases the cubes.
To avoid property damage:
•Copper tubing is recommended for the water supply line. Water supply tubing should be 1/4". Plastic is not recommended since it greatly increases the potential for water leaks.
•Do not install water supply tubing in areas where the temperature falls below freezing.
•Connect the ice maker to a drinkable water source that is not tied into a water softening system. Chemicals from the softener may damage the ice maker, causing it to malfunction.
Supplies Required for Installation
The following items are required to install the ice maker.
a)1/4 inch copper supply line with shut off valve.
b)1/4 inch brass compression nut and ferrule (sleeve).
•The copper tubing and shut off valve should be available at your local hardware or plumbing supply store. Coil enough tubing in the back of the unit to allow movement for cleaning.
Tools Required for Installation
Plastic putty knife
Phillips screwdriver
1/4-inch socket wrench or nut driver Adjustable wrench
Needle nose pliers
Power drill with Phillips bit #2
1
English
Parts Included
1. |
Ice Maker with Power Cord |
8. |
Steel Clamp (Qty-1) |
2. |
Ice Container |
9. |
Plastic Clamp (Qty-2) |
3. |
Plastic Water Supply Tubing |
10. |
Water Valve (Qty-1) |
|
with Plastic Nut |
11. |
Water Inlet Tube (Qty-1) |
|
|
4.Self-Tapping Screws (Qty-2)
|
|
12. Hex-Head Screw for |
5. |
Pan Head Screws (Qty-2) |
Water Line Clamp (Qty-1) |
6. |
Leveling Bracket Screw (Qty-1) |
13. Owner’s Manual & |
|
|
Installation Instructions |
7.Leveling Bracket (Qty-1)
1
2
3
4 |
5 |
6 |
10
7 |
8 |
9 |
|
|
12
11
13
2
English
Installation Instructions
1.Unplug the refrigerator from the power outlet and move it out for easier access.
2.Remove the ice tray rack by unscrewing the Phillips head screws.
3.Remove the freezer shelf by pushing the shelf to your left until the right side is free from the holes. Lift the shelf gently and remove.
4.There are 2 plugs on the left side wall and one on the back wall in the freezer compartment that must be removed. The holes are used to mount the ice maker and to pull through the water inlet tube.
(See fig. # 1 )
(Figure 1)
5.Remove the electrical plug cover that is mounted on the freezer back wall.
6.Unscrew the rear access panel that covers the compressor compartment. (See fig. # 2)
(Figure 2)
7.Pull out the water fill tube grommet from the rear of the refrigerator. (See fig. # 2)
3
Loading...