Fisher & Paykel WB24SDEB2, WB30SDEB1, WB24SDEX2, WB30SDEX1, WB30SPEX1 Installation Guide
WARMING DRAWER
MINIMAL WB24SDEB2 & WB30SDEB1
CONTEMPORARY WB24SDEX2 & WB30SDEX1
PROFESSIONAL WB30SPEX1
INSTALLATION GUIDE
US CA
CONTENTS
Safety and warnings 4
Warming drawer models 5
Unpack your product 6
Parts supplied 7
Tools required 7
Product dimensions - 24" minimal & contemporary models 8
Product dimensions - 30" minimal & contemporary models 9
Product dimensions - 30" professional models 10
Cabinetry dimensions - 24" minimal & contemporary models 11
Cabinetry dimensions - 30" minimal & contemporary models 12
Cabinetry dimensions - 30” professional models 13
Installation options 14
Installing the drawer 16
Adjusting the depth 17
Adjusting the height 17
Installer checklist 18
3
SAFETY AND WARNINGS
!
WARNING!
Tip Hazard
This product may tip. Keep children away and
take care. Failure to follow this advice may
result in injury.
• Drawer must be secured in place by supplied
screws.
Electric Shock Hazard
Failure to follow this advice may result in
electrical shock or death.
• If the product is damaged, switch the appliance
off and disconnect it from the mains to avoid
possible electric shock.
!
WARNING!
• Ensure there is a fixed shelf directly above
!
the drawer if it is not installed under another
product.
!
WARNING!
Cut Hazard
Failure to use caution could result in injury.
Weight Hazard
Failure to follow this advice may result in
damage or personal injury.
• Ensure the bottom shelf of the cabinetry can fully
support the weight of combined appliances.
WARNING!
• Take care: some edges may be sharp.
• Do not put fingers in the drawer when closing.
4
SAFETY AND WARNINGS WARMING DRAWER MODELS
READ AND SAVE THIS GUIDE
WARNING!
To reduce the risk of fire, injury to persons or damage when using the appliance, follow the
important safety guides listed below. Read all the instructions before using the appliance.
Installation
z
Please make this information available to the person installing the product.
z
The appliance must be installed by a qualified installer, or Fisher & Paykel trained and
supported service technician to avoid faulty electrical connection.
z
Ensure the installation complies with all clearance requirements and applicable standards
and regulations.
z
When installed in combination with a companion product, the companion product can be
placed directly onto the appliance. A built-in shelf at the base of the cabinetry must be
able to support the weight of both products.
z
Ensure the cabinetry is square and level and with correct dimensions.
z
If installing the appliance directly underneath an oven, ensure you do not damage the
oven’s lower trim. Fisher & Paykel does not accept any responsibility for any damage
resulting from incorrect installation.
z
Before installing the appliance, inspect for any signs of damage. Do not install or use
damaged appliances.
z
Be careful when stacking the appliances on top of each other to avoid damage to the
appliances.
Electrical
z
All connections for electrical power and earthing must be done by a qualified electrician
and must comply with local codes and ordinances.
z
Before installation, ensure that the voltage and frequency listed on the data plate
corresponds with the household electrical supply.
z
When combining with another appliance, ensure each appliance has its own power outlet.
Avoid sharing the power point to prevent accidental switching off of the appliance.
z
Ensure your appliance is properly grounded (earthed).
z
Connect the drawer to a properly rated, protected and sized power supply circuit to avoid
electrical overload.
z
Do not use an extension cord or a portable electrical outlet device (e.g. multi-outlet outlet
box) to connect the drawer to the power supply. Ensure the power supply cord is located
so that it will not be stepped on, tripped over or otherwise subject to damage or stress.
z
Ensure there is a switched outlet in an easily accessible area within 35 7/16” (900mm) of
the centre rear of the product.
24" Warming Drawer,
Minimal style
WB24SDEB2
30" Warming Drawer,
Minimal style
WB30SDEB1
24" Warming Drawer,
Contemporary style
WB24SDEX2
30" Warming Drawer,
Contemporary style
WB30SDEX1
Servicing
z
Do not repair or replace any part of the appliance unless specifically recommended in the
user guide. All other servicing should be done by a Fisher & Paykel trained and supported
service technician or qualified person.
z
Always disconnect the power supply before doing any installation, maintenance or repair
work, and cleaning.
z
If the power supply cord is damaged, it must be replaced by a qualified electrician or
Fisher & Paykel trained and supported service technician.
30" Warming Drawer,
Professional style
WB30SPEX1
5
UNPACK YOUR PRODUCT ELECTRICAL SPECIFICATIONS
Remove the warming drawer and accessories box from the packaging. Recycle the materials
that can be reused. Dispose packaging materials in accordance with local regulations on waste
disposal.
Inspect the warming drawer for any signs of damage. Do not install the warming drawer if it
has been damaged. If the product is damaged, contact your local Fisher & Paykel dealer.
RECYCLE
RESPONSIBLY
All electrical work must be done by a qualified electrician, or a Fisher & Paykel trained and
supported service technician.
WB24 WB30
Supply 110 VAC, 60 Hz 110 VAC, 60 Hz
Service 10 amp circuit 10 amp circuit
Maximum Power 810 W 810 W
Power outlet* 3-prong grounding-type 3-prong grounding-type
Power cord (total length) 70 7/8" (1800mm) 70 7/8" (1800mm)
* The power outlet must be earthed and located within 35 7/16” (900mm) of the centre rear of the product.
6
Loading...