Fisher & Paykel OR90 Series, OR90SCI1, OR90SCI4, OR90SCI6, OR90SDI6 Installation Manual
OR90 Induction models
FREESTANDING COOKER
INSTALLATION GUIDE
NZ AU
3
1SAFETY AND WARNINGS
IMPORTANT!
SAVE THESE INSTRUCTIONS
The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country,
please go to our website fisherpaykel.com or contact your local Fisher & Paykel dealer.
IMPORTANT SAFETY INSTRUCTIONS!
●
To avoid hazard, follow these instructions carefully before installing or using this
appliance.
●
Please make this information available to the person installing the appliance - doing so
could reduce your installation costs.
●
This appliance must be installed and connected to the mains power supply only by a
suitably qualified person according to these installation instructions and in compliance
with any applicable local building and electricity regulations. Failure to install the
appliance correctly could invalidate any warranty or liability claims.
●
If the power supply cable is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified person in order to avoid a hazard.
●
Isolating switch: make sure this cooker is connected to a circuit which incorporates an
isolating switch providing full disconnection from the power supply in accordance with
the wiring rules.
●
The cooker must be earthed.
●
Do not use adaptors, reducers or branching devices to connect the cooker to the mains
electricity supply, as they can cause overheating and burning.
●
Check for damaged after unpacking and that the cooker door closes correctly.
●
Some appliances are supplied with a protective film on steel and aluminium parts. This
film must be removed before using the appliance.
●
Packing elements (i.e. plastic bags, polystyrene foam, nails, packing straps, etc.) should
not be left around within easy reach of children, as these may cause serious injuries.
●
Make sure you recycle the packaging material where possible.
●
The manufacturer accepts no responsibility for the incorrect installation of appliances.
Incorrect installation may result in personal injury, damage to property and may
invalidate any warranty or liability claims.
●
Do not modify this appliance.
●
Before disposing of any appliance, make sure that it can no longer be used and that all
hazardous parts are removed or made harmless, so that children playing with the old
appliance cannot harm themselves.
●
The various components of the appliance are recyclable. Dispose of them in accordance
with the regulations in force in your country. If the appliance is to be scrapped, remove
the power cord.
WAR NI NG!
Cut Hazard
Take care – some edges are sharp.
Failure to use caution could result in injury or cuts.
WAR NI NG!
Electrical shock hazard
Before carrying out any work on the electrical section of the appliance, it
must be disconnected from the mains electricity supply.
Connection to a good ground wiring system is absolutely essential
and mandatory.
Alterations to the domestic wiring system must only be made by a qualified
electrician
Failure to follow this advice may result in electrical shock or death.
WAR NI NG!
To reduce the risk of tipping the appliance, the appliance must
be secured by properly installed anti-tip device packed with
the appliance.
●
A child or adult can tip the cooker and be killed.
●
Install the anti-tip device to the structure by fastening the
supplied bracket to the floor and wall following the instructions
for installing the anti-tip device.
●
Engage the anti-tip device.
●
Re-engage the anti-tip device if the cooker is moved.
Failure to do so can result in death or serious burns to children
or adults.
GENERAL INSTALLATION INFORMATION
Cleaning and servicing
●
Service should only be performed by an authorised technician.
●
Always disconnect the appliance from mains power supply before carrying out any
maintenance operations or repairs.
●
When removing appliance for cleaning and/or service:
●
Disconnect power supply.
●
Carefully remove the cooker by pulling outward.
●
The misuse of oven door (eg stepping, sitting, or leaning on them) can result in potential
hazards and/or injuries.
●
When installing or removing the cooker for service, a rolling lift jack should be used.
Do not push against any of the edges of the cooker in an attempt to slide it into or out
of the installation. Pushing or pulling a cooker (rather than using a lift jack) also increases
the possibility of bending the leg spindles or the internal coupling connectors.
IMPORTANT!
●
Cooker is heavy; use care in handling.
●
Do not lift the cooker by the oven door handle or hob rail, or by lifting the cooktop trim
as this may damage the appliance.
Replacement parts
Only authorised replacement parts may be used in performing service on the cooker.
Replacement parts are available from factory authorised parts distributors.
Contact the nearest parts distributor in your area.
4
IMPORTANT!
THIS APPLIANCE MUST BE INSTALLED BY A QUALIFIED INSTALLER.
●
Improper installation, adjustment, alteration, services, or maintenance can cause injury or property damage.
Consult a qualified installer or the service agent.
●
The use of suitable protective clothing/gloves is recommended when handling or installing this appliance.
2PARTS SUPPLIED FOR INSTALLATION
3TOOLS NEEDED FOR INSTALLATION (NOT SUPPLIED WITH THE APPLIANCE)
Screwdriver Pencil Tape measure Suitable
protective gloves
Hammer Adjustable
wrench
Adjustable
pliers
Drill
Screws and plastic
sleeve anchors (2)
Anti-tip bracket
and lock pin (1)
5
4MODEL IDENTIFICATION
OR90SCI1
OR90SCI4
OR90SCI6
OR90SDI6
NOTE: Model features may vary
OR90 INDUCTION MODELS
5PRIOR TO INSTALLATION
Unpacking and handling
●
Inspect the cooker to verify that there is no shipping damage. If any damage is detected, call the shipper and initiate a damage claim. Fisher & Paykel is not responsible for shipping damage.
●
DO NOT discard any packing material until the cooker has been inspected.
●
Remove the outer carton and any packing material from cooker. Some models are supplied with a protective film on steel and aluminum parts.
This film must be removed before installing or using the appliance.
6
6PRODUCT DIMENSIONS
FRONT
TOP
SIDE
E
B
C
C
A
D
F
G
PRODUCT DIMENSIONS
OR90SCI MODELS
mm
A
Overall height of cooker
(from floor to top of cooktop, excluding optional backguard)
min 898
max 946
B
Overall width of cooker
897
C
Overall depth of cooker
(from front of cooker to rear of island trim/backguard,
excluding handles and dials)
600
D
Height of optional backguard from top of cooktop
(supplied with some models only)
60
E
Height of chassis (excluding adjustable feet)
813
F
Adjustable feet height
min 85
max 133
G
Depth of open door to front of cooker
451
NOTE: Model features may vary
Optional kickstrip available (purchased separately)
Loading...